Operation; Basic Operation; Adjusting The Treble; Adjusting The Balance - Clarion AX410 Owner's Manual

7. OPERATION

Note:
• Be sure to read this chapter referring to the front diagrams of chapter 2. CONTROLS on page 3 (unfold).

Basic Operation

CAUTION
When this unit is turned on, starting and stop-
ping the engine of a car with its volume raised
to the maximum level may harm your hearing.
Be careful about adjusting the volume.
1) Press the POWER button 4.
* To turn the power off, press the POWER button for
at least 1 second.
2) Press the FNC button 4 to select the opera-
tion mode. The mode switches as follows
each time the FUNC button is pressed:
Radio Tape CD changer
If a component is not connected, that operation
*
mode cannot be selected.
"NO CASS" appears when no tape is loaded in
*
the source unit, and "NO DISC" appears when no
disc is loaded in the CD changer.
3) Turning the Rotary knob 2 clockwise
increases the volume; turning it counterclock-
wise decreases the volume.
* The volume level is from 0 (minimum) to 33 (max-
imum).
Audio Mode Adjustments
Press the A-M button 3 to select the adjustment
mode. The mode switches as follows each time
the A-M button is pressed:
BASS TREB
mode

Adjusting the Bass

1) Press A-M button 3 and select "BASS".
2) Turning the Rotary knob 2 clockwise empha-
sizes the bass; turning it counterclockwise
attenuates the bass.
The factory default setting is "0". (Adjustment
*
range: –6 to +6)
3) When the adjustment is complete, press A-M
button 3 several times until the function
mode is reached.
8
AX410
Radio
BAL FAD Previous

Adjusting the Treble

1) Press A-M button 3 and select "TREB".
2) Turning the Rotary knob 2 clockwise empha-
sizes the treble; turning it counterclockwise
attenuates the treble.
* The factory default setting is "0". (Adjustment
range: –6 to +6)
3) When the adjustment is complete, press A-M
button 3 several times until the function
mode is reached.

Adjusting the Balance

1) Press A-M button 3 and select "BAL".
2) Turning the Rotary knob 2 clockwise empha-
sizes the sound from the right speaker; turn-
ing it counterclockwise emphasizes the sound
from the left speaker.
The factory default setting is "0". (Adjustment
*
range: L9 to R9)
3) When the adjustment is complete, press A-M
button 3 several times until the function
mode is reached.

Adjusting the Fader

1) Press A-M button 3 and select "FAD".
2) Turning the Rotary knob 2 clockwise empha-
sizes the sound from the front speakers; turn-
ing it counterclockwise emphasizes the sound
from the rear speakers.
The factory default setting is "0". (Adjustment
*
range: F9 to R9)
3) When the adjustment is complete, press A-M
button 3 several times until the function
mode is reached.
Setting the Z-enhancer
This unit comes with three types of sound tone
effects stored in memory. Select the one you prefer.
The factory default setting is "Z-EHCR OFF".
*
Each time you press Z-EHCR button @, the
tone effect changes in the following order.
"Z-ENHANCER 1"
"Z-ENHANCER 3"
"Z-ENHANCER 1"...
"Z-ENHANCER 2"
"Z-EHCR OFF"