Table of Contents
Advertisement
Bar graph lateral setting:
The bar graph lateral mode allows you to adjust the G force scale for
lateral acceleration (cornering) as shown on the gauge when operating
on the lateral axis in real time mode. For example, if you set the "bGL"
to 1g, when the bar is fully lit on either side, the vehicle is achieving 1g
of force or more during cornering.
To select bar graph lateral mode, enter Setup, then press A until "bGL"
is displayed. Press ENTER to confirm. The current setting should be
displayed, and can be adjusted up and down from .3 to 2.0 G's using the
A and C buttons. When the desired result is displayed, press ENTER to
confirm.
Reaction time:
Enabling this function allows the gauge to test your reaction time while
in the 1/4 mile mode only. With reaction time on, the gauge will perform
a dragstrip "Christmas Tree" start and then measure the time it takes
between when it displays "Go" and when the vehicle starts to move.
• To enable or disable reaction time, enter Setup mode, and press A
until "rEAC" is displayed. Press ENTER to confirm. The display will
then read "on" if reaction time feature is enabled, or "oFF" if it is
disabled.
• To enable reaction time, press A. To disable, press C. When the
desired result is displayed, press ENTER to confirm.
Start G's:
The Starting G's setting allows the customer to adjust the sensitivity of
the accelerometer within the performance gauge. This setting affects
how quickly the gauge detects movement of the vehicle when
determining vehicle start time. Too low of a setting may result in false
starts due to engine vibration. Too high of a setting may result in the
gauge not properly detected at the start of the run. The gauge has been
optimally programmed to 0.7 G's for this vehicle.
Display on/off:
This allows the customer to turn on/off the performance gauge LED bar
graph and seven segment displays. To enable Display on/off,
simultaneously hold down buttons A and C to turn off the display. The
gauge will display "DOFF" before turning off the display. To exit Display
on/off, press any of the three front panel buttons. The gauge will then
momentarily display "DON" and then enter the Real time operating
mode. The LED bar graph and seven segment display will be turned off.
The Ford oval will be illuminated during display off.
Boss 302 Unique Features
17
Advertisement
Table of Contents
