Table of Contents
Advertisement
Boss 302 Unique Features
To enter/modify vehicle weight, do the following:
1. Repeatedly press the MODE button until "SUP" is displayed.
2. Press ENTER to confirm.
3. Press A until "ULBS" is displayed.
4. Press ENTER to confirm. The value displayed is total vehicle weight in
pounds (lb). To increase the value, either press or press and hold the A
button. To decrease, press or press and hold the C button. Weight is
adjusted in ten pound increments and can be set to any value from
500 lb (227 kg) to 8,000 lb (3629 kg).
5. When the correct value is reached, press B to confirm.
6. To exit and return to real time display, press EXIT (C button). A
lower than actual weight setting will result in a lower than expected
horsepower reading. The opposite is true with a higher than actual
weight setting.
Bar graph forward high setting:
The bar graph forward high mode allows you to adjust the G force scale
for forward acceleration as shown on the gauge when operating on the
forward axis in real time mode. For example, if you set the "bGFH" to
1g, when the bar is fully lit on the right hand (acceleration) side, the
vehicle is achieving 1g of acceleration force or more.
To select bar graph forward high mode, enter Setup, then press the A
button until "bGFH" is displayed. Press ENTER to confirm. The current
setting should be displayed, and can be adjusted up and down from .3 to
2.0 G's using the A and C buttons. When the desired result is displayed,
press ENTER to confirm. The bar graph high setting is preset to 0.7G.
Bar graph forward low setting:
The bar graph forward low mode allows you to adjust the G force scale
for rearward acceleration (deceleration or braking) as shown on the
gauge when operating on the forward axis in real time mode. For
example, if you set the "bGFL" to 1g, when the bar is fully lit on the left
hand (deceleration) side, the vehicle is achieving 1g of force or more
during braking.
To select bar graph forward low mode, enter Setup, then press the A
button until "bGFL" is displayed. Press ENTER to confirm. The current
setting should be displayed, and can be adjusted up and down from .3 to
2.0 G's using the A and C buttons. When the desired result is displayed,
press ENTER to confirm. The bar graph low setting is preset to -0.7G.
16
Advertisement
Table of Contents
