Table of Contents
Advertisement
Troubleshooting
What is it doing?
The connected speaker is
unresponsive.
The Dante Controller
application cannot locate the
amp
The Vaddio Deployment Tool
cannot locate the amp.
Operation, Storage, and Care
For smears or smudges on the product, wipe with a clean, soft cloth. Use a lens cleaner on the lens. Do
not use any abrasive chemicals.
Keep this device away from food and liquids.
Do not operate or store the device under any of the following conditions:
Temperatures above 104° F (40° C) or below 32° F (0° C)
n
n
High humidity, condensing or wet environments
n
Inclement weather
Severe vibration
n
In a hydraulic press
n
Dry environments with an excess of static discharge
n
Do not attempt to take this product apart. There are no user-serviceable components inside.
Complete Manual for the EasyIP AMP D Network-Connected Amplifier
Possible causes
The cable from the amp to the
speaker is not fully seated at
one end, or is bad.
The amp is not paired to the
host device.
The cable from the EasyIP
AMP D to the EasyIP Switch
is not fully seated at one end,
or is bad.
EasyIP audio devices are not
available through the Vaddio
Deployment Tool.
Check the cable for correct pin-out and
continuity.
Use the Dante Controller application to
pair the amp with the host device.
Check the cable for correct pin-out and
continuity.
Use the Dante Controller application to
locate the amp.
10
Check and correct
Advertisement
Table of Contents
