Routing A Multicast Flow To Speakers Or Amps - LEGRAND VADDIO EasyIP AMP D Complete Manual

Routing a Multicast Flow to Speakers or Amps

D C
ANTE ONTROLLER APPLICATION
1. In the Dante Controller application, go to the Network view and select the Routing tab.
2. Under Dante Receivers, find the rows for the amp and speakers
3. In the Network View, look under Dante Transmitters to find the column for the desired output from the
host device, Mix Output 1.
4. Select the box where each Dante receiver device intersects with the Mix Output 1 channel.
Note
In addition to the audio routing for the speakers and amplifier, this screen shot also shows four
microphones using the same audio from Mix Output 1 as the AEC reference. The microphones are set up
to deliver four channels of audio to the host device. Refer to the manual for your EasyIP microphone for
details on setting up the multicast flows and using the microphones' passthrough channel.
Complete Manual for the EasyIP AMP D Network-Connected Amplifier
9