Table of Contents
Advertisement
Asphalt and concrete cutters
For optimal service life of the cutting disc, the
operator should work carefully and sensitively.
Do not force the machine!
4.2.4. Cutting Depth Scale
Cutters RZ 120, RZ 170 and RZ200 have just
informative cutting depth scale. Turning the
4.3. Engine Turning-Off
1. Shift the throttle control lever to idle
position. (see point 4.1.1.4).
2. Let the engine to idle for a while to cool
down.
4.4. Handling, Transport, Storing
When handling the machine keep safety
regulation shown in this manual and well as
4.4.1. Manual Handling
For manual lifting, cooperation of mode people
is required. Hold the machine by frame or the
base plate. Never lift the machine by engine.
4.4.2. Handling by Crane
Use a crane of sufficient payload (see Technical
Data). Observe the regulations valid for
operation of cranes. Only qualified personnel
may carry out this work.
4.4.3. Handling by Forklift
Should be the machine extensively handled by a
forklift (as when sending it by a parcel service),
it is recommended to palletize it. For one
4.4.4. Transport
Secure the machine against rolling over, falling
down or sliding on the carrier. Fasten the
binding means to suitable points at the frame.
4.4.5. Storing
Store the machine on a safe place, secured from
theft and misuse. We recommend an indoor dry
place, without excessive concentration of
chemical agents and dust.
4.5. Special Conditions of Operation
4.5.1. Work at Low Temperatures
The cutter is able to work even at low
temperatures. Let the engine to warm up
sufficiently before commencing the work.
Page 17
Nevertheless, lifetime of the disc may vary
depending on the material to be cut and other
factors.
handle for 360 degrees lowers the blade for
about 15 mm.
3. Turn the ignition switch to "OFF".
4. Close the fuel tap
general safety rules valid for operation of lifting
or hoisting equipment.
Fasten the lifting cable to the marked point at
the machine.
machine use "small" palette (0,8x0,6m), for two
machines standard EUR pallet (1,2x0,8m).
NOTE:
The machine must be kept in upright position. If
overturning happens, see point 3.5.
Prior to long-term storing clean the machine,
repair the paint and apply suitable preservation
agents. Mark visibly that the machine has been
conservated.
In case that the machine is difficult to start, let it
warm up at room temperature first.
Operation manual
issued 01/2017
Advertisement
Table of Contents
