Mounting The Saw Chain And Blade; Tightening And Checking The Saw Chain; Lubricating The Chain; Mounting The Saw Head On The Telescopic Handle - Parkside PAHE 20-Li C3 Translation Of The Original Instructions

Mounting the saw chain and blade

WARNING!
► Wear protective gloves! There is a danger
of injury from the sharp cutting teeth!
► The sprocket cover
tensioning ring
are not pre-assembled on the appliance at
delivery.
► The turning of the blade
the manufacturer.
► The chain travel direction
blade must be adhered to every assembly.
♦ Place the saw chain
Ensure that the saw chain
the correct direction (see Fig. B).
♦ Attach the blade
upwards and guide the saw chain
the chain sprocket
The guide rail must be above the blade
guide (see Fig. C).
♦ Put the sprocket cover
♦ Tighten the fixing screw
♦ Now, tighten the saw chain
Tightening and checking the saw chain).
♦ Tighten the fixing screw
Tightening and checking
the saw chain
WARNING!
► Wear protective gloves! There is a danger of
injury from the sharp cutting teeth!
♦ Undo the fixing screw
♦ Turn the chain tensioning ring
direction to increase the tension.
♦ The saw chain must lie against the underside
of the blade.
Check whether the saw chain
over the blade by hand
♦ Now tighten the fixing screw
■ 12 │ GB │ IE
together with the chain
and the fixing screw
is not intended by
on the
on the blade .
is running in
with the labelling facing
around
.
on.
slightly.
(see section
completely.
.
in a clockwise
can be drawn
.
completely.
NOTE
► A new saw chain
tightened more regularly.

Lubricating the chain

♦ Remove the oil filler cap
♦ Fill the oil tank with approx. 65 ml of organic
chain oil .
WARNING!
► Never work without chain lubrication!
If the saw chain
equipment may become irreparably
damaged within a short time. Always check
chain lubrication and oil level
before starting work.
NOTE
► Use only saw chain oil. Preferably biodegrad-
able. Do not use waste oil, motor oil, etc.
► While working, check whether the automatic
chain lubrication is working correctly. Check
the chain lubricator before and during work.
Mounting the saw head on the
telescopic handle
♦ Place the lower end of the saw head
upper end of the telescopic handle
the saw head can be pushed through as far
13a
as the black plastic ring. Make sure that the
groove and the recess interlock with each other.
♦ Tighten the red connecting piece
it towards the symbol on the saw head

Sharpening the saw chain

NOTE
► You will find detailed information on
sharpening in the sharpening set.
► Alternatively, you can use an electrical saw
chain sharpening device and follow the
instructions of the manufacturer.
► If you have any doubts about implementing
the work, the saw chain
replaced.
stretches and must be
.
runs dry, the cutting
in the tank
on the
13a
so that
by turning
1a
13a
should be
PAHE 20-Li C3
.