Related Manuals for EAST OAK BRAZI GFT22001
Summary of Contents for EAST OAK BRAZI GFT22001
- Page 1 BRAZI Fire Pit Table 60000 BTU Owner’s Manual MODEL: GFT22001 | GFT22002 | GFT22003 GFT22004 | GFT22005 | GFT22006 GFT22007 | GFT22008 | GFT22009...
- Page 3 eastoak.com Questions? Comments? Reach out to us to for expert support! support@eastoak.com eastoak.com 1-833-EAST-OAK (USA) (1-833-327-8625) Follow eastoakliving on Claim your 3-year warranty at eastoak.com/warranty EASTOAK.COM FIRE PIT TABLE...
-
Page 4: Important Caution
IMPORTANT CAUTION CAUTION: PLEASE READ ENTIRETY OF MANUAL PRIOR TO ASSEMBLY AND OPERATION. Verify all parts and components are present. Check all pieces for any damage before assembly. If any parts are damaged or missing, contact customer service at support@eastoak.com. •... - Page 5 WARNING • This product is for outdoor use only. • All installation, service, and repair must be performed by a qualified technician or gas supplier. • Do not store this product close to any gasoline and any flammable vapors or liquids. •...
-
Page 6: Safety Guide
SAFETY GUIDE • Your safety and the safety of others are important to us. This manual provides safety guidelines to prevent any damage, injury, or death. Please read all points thoroughly and follow these steps to ensure optimal protection for you and your family. •... -
Page 7: Care And Maintenance
CARE AND MAINTENANCE Thank you for trusting us with your purchase! We are excited for you to experience warmth in luxury. To ensure the lifespan of your product, here are some care and maintenance tips. WARNING • Before any service or maintenance, allow the heater to cool down completely. This may take at least 45 minutes. -
Page 8: Stove Dimensions
STOVEDIMENSIONS 1-833-327-8625 SUPPORT@EASTOAK.COM... -
Page 9: Parts Diagram
PARTS DIAGRAM size 44in. 52in. 57in. EASTOAK.COM FIRE PIT TABLE... - Page 10 ASSEMBLY INSTRUCTIONS This product requires 2 people to assemble. Before assembly, please read the entirety of this manual to ensure safety and proper usage. Keep in mind there are a variety of steps. Place all parts and hardware on a flat surface. Inspect each piece and ensure there is no damage or missing pieces.
- Page 11 Assemble the panels (E, F x2, G, H) as shown below and secure them together using 8 screws (BB). 5Place the burner unit on top of the unit. Fasten screws (BB x 4, I) tightly. EASTOAK.COM FIRE PIT TABLE...
- Page 12 Secure door panel to unit using screws (DD x4, J x4). Secure center piece using 4 screws (BB x4). Align two screws on the top side. Then, turn the unit upside down and fasten two screws on the bottom side. 1-833-327-8625 SUPPORT@EASTOAK.COM...
- Page 13 The direction of the front door faces the direction of the heat shield EASTOAK.COM FIRE PIT TABLE...
- Page 14 Place lava or glass rocks into the burner. ATTENTION: • Do not put more than 4 lbs of lava rocks or 9 lbs of glass rocks into the burner. • Do not touch or arrange the lava rocks once the product is in use.
-
Page 15: Assembly Instruction
ASSEMBLY INSTRUCTION (LPG cylinder) LIQUEFIED PETROLEUM GAS (LPG) SAFETY INFORMATION LPG cylinder used with the product must be: • Constructed and marked in accordance with the U.S.Department of Transportation (DOT) specification for LPG cylinder, CAN/CSAB339, Cylinders, Spheres, and Tubes for the Transportation of Dangerous Goods, as applicable;... - Page 16 ASSEMBLY INSTRUCTION (LPG cylinder) LPG cylinder connection • Inspect the entirety of the gasket for any sign of damage or erosion. Position the LPG cylinder in the firepit and secure the unit using the retainer bolt. • ATTENTION: Ensure the valve on the fire pit and LPG cylinder are set to the “OFF”...
-
Page 17: Lighting Instructions
Lighting Instructions • Ensure the fire pit control knob is set to the “OFF” position. • Turn on the gas cylinder valve by pressing the knob and turning it counterclockwise to the “IGNITOR” position. This is indicated by a lighting symbol. - Page 18 OPERATION INSTRUCTION (Turning Off) Turning OFF • To shut down the unit, turn the control knob clockwise to the “OFF” position. • Turn off the gas cylinder and disconnect the regulator when appliance is not in use. • Allow adequate time for the heater to cool down completely before transporting it.
- Page 19 ASSEMBLY INSTRUCTION (LPG cylinder) LPG cylinder disconnection • Allow unit to completely cool down after use. Then, ensure LPG cylinder valve is shut and cooled down. Control knob on unit must be in the “OFF” position. • Next, turn the coupling nut counterclockwise until the regulator detaches. •...
- Page 20 OPERATION INSTRUCTION (Leak Check) AWARNING • All leak tests must be performed outdoors. • Extinguish all open flames in the appliance before testing for any leaks. • DO NOT smoke when performing a leak test. • DO NOT use the appliance until all connections have been tested and there is confirmation that no leaks are present.
- Page 21 OPERATION INSTRUCTION (Ignition) Before operating the appliance: • Ensure the gas line is properly connected and there is no holes or damage to the hose. • Ensure there are no leaks (see page 12 for how to check for leaks). •...
-
Page 22: Troubleshooting
TROUBLESHOOTING Problem Possible Cause Solution Ensure the regulator is attached to the cylinder valve. Open the LPG cylinder valve is closed valve. Manually tighten the coupling Coupling nut not fully connected nut to the cylinder valve. Refill or replace the LPG Low or empty LPG cylinder cylinder Electrode and burner are wet... -
Page 23: Warranty And Service
Replace LPG cylinder WARRANTY AND SERVICE GUARANTEED 3-YEAR WARRANTY Thank you for choosing East Oak. This product is covered by our company warranty for up to 3 years from its original purchase date. CLAIM WARRANTY If you’d like to claim your product’s warranty, register your new product on our website at www.eastoak.com/warranty. - Page 24 BRAZI Fire Pit Table Series 1-833-327-8625 SUPPORT@EASTOAK.COM...
- Page 26 support@eastoak.com eastoak.com 1-833-EAST-OAK (USA)