Operation Panel Screen - Denso Keyence Vision XG Series Manual

7. Operation Panel Screen

This provider provides the following operation panel screen. This operation panel uses the provider to check
operations, etc. after connecting to the device. See the following as an application example of the operation panel.
Displaying the operation panel establishes connection to XG (implements the provider). The communication settings
need to be configured beforehand. Closing the operation panel terminates the connection (releases the provider).
2
1
4
3
7
5
6
8
Description
Each button functions as follows.
1. Changes to the "run mode". (ChangeMode)
2. Changes to the "stop mode". (ChangeMode)
3. Configures the inspection setting number SD card number : 1 to 2, setting No.: 0 to 999
4. Changes to the setting No. set in the step 3. (ChangeInspectSetting)
5. Configures the variable name to read. (This variable name is a name configured in the XG series.)
6. Reads out the value of the variable set in (5). Received data appears in the data display section (10).
(ReadVariable)
7. Executes all triggers. (Trigger)
8. Displays the processing result.
9. Moves up the page displayed for received data.
10. Displays the received data.
11. Moves down the page displayed for received data.
Note 1: When a provider implementation (initialization) is done properly, "Connected" is displayed in the field 8.
Note 2: Do not use the operation panel screen when the XG provider is used by PacScript program.
[Main screen]
33
画像処理システム／ＸＧシリーズ
9
10
11