Table of Contents
Advertisement
•
Input: Select the source from HDMI1(2.0), HDMI2(2.0), HDMI3(2.0),
HDMI4(2.1), DP or TYPE C.
•
Auto Source: Select On to enable auto search for signal source in order or Off
to disable this function.
•
Wide Mode: Select your preferred screen aspect from Full, Aspect, 1:1 or 21:9.
•
PIP/PBP Mode: Select Mode from Off (function is disabled) or from any of the
following:
- PIP Large/PIP Small: Displays the sub source in a large window or small
window respectively. After you select this option, select the PIP Position from
Top Left, Top Right, Bottom Right or Bottom Left and Sub Source from
HDMI1(2.0), HDMI2(2.0), HDMI3 (2.0), HDMI4(2.1), DP or TYPE C. Then
select Source Swap to swap the main source and sub source. Finally select
Audio Source from Main (source) or Sub (source).
- PBP: Displays the main source and sub source next to each other. Select
the PBP Size from Aspect and Full, select Sub Source from HDMI1(2.0),
HDMI2(2.0), HDMI3 (2.0), HDMI4(2.1), DP or TYPE C. Then select Source
Swap to swap the main source and sub source. Finally select Audio Source
from Main (source) or Sub (source).
•
Hot Key Assignment: Select the function of Hot Key 1 and Hot Key 2 from
Modes, Brightness, Volume, Gamma, Contrast, PIP/PBP, USB Port Select.
•
Display Data Channel (DDC)/Command Interface (CI): Configure monitor
settings remotely from PC that is connected to the monitor. Select On to enable
this function or Off to disable.
•
HDMI Black Level: Select the HDMI Black Level from Normal or Low.
•
Quick Start Mode: Select On to speed up boot speed or Off to disable the
function.
•
USB Port Select: Set the USB port type to C-Type or B-Type or Auto.
•
USB 3.2: Select On to enable USB 3.2 or Off to disable the function.
Note:
If your phone supports USB Type-C connection but cannot display on the
screen, please turn on USB3.2 at OSD menu.
23
CG48 User Guide English
Advertisement
Table of Contents
