Clas Ohlson HYW226GO Assembly Instructions

Wall Clock Kit
Art.no 36-6344, 36-6345 Model HYW226GO, HYW226BK
Please read the entire instruction manual before using the product
and then save it for future reference. We reserve the right for
any errors in text or images and any necessary changes made
to technical data. In the event of technical problems or other
queries, please contact our Customer Services.
Assembly
1. Mark the mounting
point on the wall by
pushing a pen through
the template hole and
making a hole in it.
2. Ensure that there are
no electrical wires or
water pipes in the wall
where you intend to
screw/drill. Screw in
an appropriate type
of screw for the wall
material. Hang the clock
movement onto the
screw.
GREAT BRITAIN • customer service tel: 020 8247 9300 e-mail customerservice@clasohlson.co.uk internet: www.clasohlson.co.uk postal: 10 – 13 Market Place, Kingston Upon Thames, Surrey, KT1 1JZ
3. Pop out the clock
numbers and hour
markings.
4. Place the first number
(e.g. the number 1 of 12
o'clock) in the desired
location and make
a mark on the wall.
In this example the tip
of the minute hand is
level with the top edge of
the number. You may of
course set the number in
any other position to suit
your needs.
5. Remove the clock
movement from the wall
and tape the template
up in its place.
Note: Make sure that
the tape you are using
does not damage
the surface of the
wall. Make sure that
the mounting hole in
the template is aligned
with the screw and that
the template is straight.
6. Peel off the backing paper
from the numbers and
other hour markings.
7. Stick the numbers
1 and 2, making 12
o'clock, at the same
height as the mark you
made previously, so
that the numbers are
centred on the template.
Use a ruler and place it
over the template and
the 12 o'clock numbers
you have just laid to
ensure correct centring.
Measure the distance
from the centre of the template circle to the edge of
the placed numbers. In this example this distance is about
20 cm. Using this reference distance, mount all the other
numbers and hour markings in the same manner around
the circumference of the circle.
8. Finally, remove the template and re-mount the clock movement.
Responsible disposal
This symbol indicates that this product should not
be disposed of with general household waste.
This applies throughout the entire EU. In order
to prevent any harm to the environment or
health hazards caused by incorrect waste
disposal, the product must be handed in for
recycling so that the material can be disposed
of in a responsible manner. When recycling
your product, take it to your local collection facility or contact
the place of purchase. They will ensure that the product is
disposed of in an environmentally sound manner.