Product Care; Troubleshooting - Talkpod A36-M7B4UV1 User Manual

17. Product Care

Do not pierce or scrape the product with any edged
instruments or hard objects.
Keep the product far away frpm substances that can
corrode the circuit.
Do not hold the product by its antenna directly.
Do not hold the product by its earpiece cable directly.
Attach the accessory jack cover when the product is
not in use Keep the product far away frpm substances
that cancorrode the circuit.
User Manual 18

18. Troubleshooting

Phenomena Analysis
The battery may be improperly installed.
The battery power may be used up.
Power-on Fallure
The battery is poorly connected due to dirtied or
damaged battery contacts.
Low battery voltage.
Low volume level.
During receving,
the voice is weak, The antenna may be loosened or improperly installed.
discontinuous or
totally inactive.
The speaker may be blocked or damaged.
The frequency or signaling may be inconsistent with
Unable to that of other members.
communicate with
The channel type(digital/anaiog)may be set inconsistently.
other members.
You may be interrupted by radios using the same frequency.
Solution
Remove the battery and reassemble it.
Remove or replace the battery.
Clean the battery contacts.If the problem cannot be solved, contact
your dealer or authorized service center for inspection and repair.
Recharge or replace the battery.
Increase the volume by rotating the Volume Control knob.
Reassemble the antenna after turning off the radio.
Clean the surface of the speaker.If the problem cannot be solved,
contact your dealer or authorized service center for inspection and
repair.
Set your TX/RX frequency and signaling to the same as that of
other members.
Make sure all members are on the same digital/analog channel.
Change the frequency，or adjust the squelch level.
19