Talkpod A36-M7B4UV1 User Manual page 9

No Secondary menu
Function function
OFF
15 VOX
1,2,...9
WIDE
16 W/N
NARR
OFF
17 VOICE
ON
OFF
18
BEEP
ON
ENGLISH
19 LANGUAGE
CHINESE
OFF
20 BCL
ON
ON
ABR
21
5s,10s,...3min
OFFSET 00.000,...,99.995
22
User Manual 12
Setting instructions
Turn off VOX function, transmitting without PTT pressing.
Activate the sound pressure intensity of voice control, level 1 is the most
sensitive.
Wide mode
Narrow mode
Turn off voice prompt
Turn on voice prompt
Turn off operation prompt
Turn on operation prompt
English
Chinese
OFF
ON
Background light is always on.
Time between the background light ON to automatically OFF.
In frequency mode, the difference between the transmitting and
receiving frequencies.
No Function function Secondary menu
TO
23 SC-REV
CO
SE
24 PF2
25 PF2 LONG PRESS
26 PF3
OFF
+
27 SFT-D
-
28 SCAN CTCSS
Setting instructions
Time scanning, the walkie-talkie pauses scanning when it detects a
signal, and after staying stopped for about 5 seconds, the walkie-talkie
will continue scanning even if the signal is still there.
Carrier scanning, the two-way radio pauses scanning when a channel is
detected and keeps it on the same frequency until the signal disappears.
There is a 2 second delay between the disappearance of the signal and
the resumption of scanning to allow time for the response to begin
transmission.
Search scanning, the walkie-talkie exits scanning when it detects a signal
and stays at this frequency.
In frequency mode, turn off the difference between the transmitting and
receiving frequencies.
In frequency mode, the TX frequency=RX frequency plus frequency
difference
In frequency mode, the TX frequency=RX frequency minus frequency
difference
13