Use Qhy163M In Ezcap_Qt - QHYCCD COLDMOS QHY163M User Manual

07 Use QHY163M in EZCAP_QT

EZCAP_QT ( V0.1.51.18 )
function for QHYCCD deep sky cameras. You can use this QHY63M camera with filter wheel in this
software.
1. Install EZCAP_QT software.
2. Connect your QHY163M to 12V power supply. Connect your QHY163M to color filter wheel with
DIN4/RJ11 cable. Connect your QHY163M to your computer with USB3.0 cable.
3. Run EZCAP_QT. Select "Connect" in Menu->Camera. If the camera is successfully connected. The
title of EZCAP_QT will display the camera firmware version and the camera ID as shown below.
4. In Menu->Camera Setup, Click "Temp Control" and set the CMOS sensor temperature.
enable the "Auto Control" and set the target temperature. For example here we set the temperature to -
10C. The CMOS temperature will come to -10C very fast (in about 2-3minute). If you want to close the
TEC, you can select "TEC OFF". If you just want to set the TEC power but not the temperature. You
can select "Manual" and then set the percent of the TEC power
is the software developed by QHYCCD. This software has the basic capture
17
QHY163M
You can