Rapid BTX10 Operator's Manual page 16

compression and the fastener may be force-
fully discharged while attempting to free a
jammed condition.
• Do not use this tacker for fastening elec-
trical cables. It is not designed for electric
cable installation and may damage the
insulation of electric cables thereby causing
electric shock or fi re hazards.
NOISE EMISSION/VIBRATION
• A-weighted sound pressure level LpA= 71.8 dB(A), uncertainty K=3
dB(A). A-weighted sound power level LwA= 82.8 dB(A), uncerta-
inty K=3 dB(A). Recommendation for the operator to wear hearing
protection.
• Vibration total value =2.447 m/s², uncertainty K=1.5 m/s². The
declared vibration total value has been measured in accordance with
a standard test method and may be used for comparing one tool
with another. The declared vibration total value may also be used in a
preliminary assessment of exposure.
WARNING
The vibration emission during actual use of the power tool can
differ from the declared total value depending on the ways in
which the tool is used. It's needed to identify safety measures to protect
the operator that are based on an estimation of exposure in the actual
conditions of use (taking account of all parts of the operating cycle
such as the times when the tool is switched off and when it is running
idle in addition to the trigger time).
LOAD STAPLES INTO THE MAGAZINE
1 Turn the tool upside down.
2 Press the magazine latch �� to unlock it from the tacker body.
3 Slide the magazine �� backwards.
4 Insert a staples strip
ASSEMBLY
. Make sure to use only Type 53 staples.
16