Operation - Royal Sovereign HCE-100 Owner's Manual

OPERATION

Keep combustible materials, such as furniture, beddings, papers, clothes, and curtains at least 1.2m (4 feet) away from the
front, the sides and rear of the heater. Not suitable for use in a bathroom or near water.
Unwind the power cord and plug in unit
Turn the Control Setting clockwise to the' 'position for fan, 'I' position for heating selection with low power, 'II' position
for heating selection with maximum power.
Turn the Thermostat setting clockwise to the maximum setting. To regulate temperature, when the room has reached the
desired comfort level, slowly turn the Thermostat setting counter-clockwise just to the point where the heater switches off
and not beyond. The temperature fixed in this way will be automatically regulated and kept at a constant level by the
thermostat.
Press Oscillation Button at the front bottom and the heater will oscillate. Press it again and the oscillation will stop.
Turn the Power Control setting to 'O' position to turn the power OFF.
Unplug the unit to turn the power OFF. The power light will go off.
SAFETY FEATURES
This heater has a built in safety features including overheat protection & Safety Tip-over Switch which will automatically shuts off
the heater if the heater is not in the upright position. The heater will resume back to normal operation when the heater is
returned to the upright position.
TROUBLESHOOTING
If your heater shuts off or fails to operate unexpectedly, one of the safety features may have been activated to prevent
overheating. Please follow next steps to reset the heater.
1. Turn the Power Control setting to 'O' position.
2. Unplug the power cord and allow 5~10 minutes for heater to cool completely.
3. Be sure the power cord is plugged into a working electrical outlet, and that the unit is not obstructed.
4. Check your Thermostat setting. The unit may simply be off because the Thermostat setting equals room temperature.
5. Check for any obstructions.
6