Champion CHGF110 User Manual page 2

16" STAND FAN
Thank you for your purchasing this fan. Please read these operating instructions through carefully before
connecting your device to the mains, in order to avoid damage due to incorrect use. Please pay particular
attention to the safety information. If you pass the device on to a third party, these operating instructions must
EN
also be handed over.
STRUCTURE
1. FRONT GUARD
2. FAN BLADES
3. GUARD MOUNTING NUT
4. BACK GUARD
5. MOTOR SHAFT
6. MOTOR HOUSING
7. OSCILLATING KNOB
8. SWITCHES
9. SWITCH COMPARTMENT
10. LOCK SPRAIN
11. UPPER PIPE
12. PIPE CONNECTOR
13. LOWER PIPE
14. ROUND BASE
15. NUT & BOLT
ASSEMBLY
1. Secure lower pipe with Pipe support to the hub of Cross Base with screw provided.
2. Extend upper pipe, insert the pipe connector through upper pipe onto lower pipe and tighten.
3. Attach the motor with switch compartment onto the upper pipe. Ensure the switch compartment is pushed fully onto the
upper pipe and secured with the screw provided.
4. Loosen Guard Mounting Nut from the Motor Housing.
5. Position Back Guard firmly to Motor Housing and then fasten by turning Guard Mounting Nut clockwise tightly.
6. Push the Blade along Motor Shaft and fasten firmly with the Blade.
7. Hang the Front Guard to Back Guard with the position fixer provided at the rim of Guard, and then fix together with clips
provided. The guard bottom nut & bolt must be fitted to ensure secure fitting.
OSCILLATION CONTROL
1. Push the oscillation knob to oscillate.
2. Pull the oscillation knob to stop
CLEANING
1. Remove all items of packaging from the fan.
2. Remove the locking nut from the motor shaft.
3. Position the rear guard over the motor shaft, ensuring that the notches are correctly aligned and then secure with the locking
nut.
4. Align the fan blade with the flat part on the motor shaft and secure by tightening the blade cap by turning counter-clockwise.
5. Attach the front guard centre hook to the middle of the rear guard and secure by pushing the guards together until they click
into position.
6. Open the locking clip. The guard bottom nut and screw must also be fitted to ensure secure fitting.
7. Always disconnect the cord from the electrical outlet when cleaning your fan.
8. Light accumulated dust may be removed from the fan with a soft cloth or vacuum cleaner using the dusting brush
attachment.
9. Wipe the exterior surfaces of the fan occasionally with a cloth moistened (not dripping wet) with a mild soap solution.
Dry the case thoroughly with a soft dry cloth before operating the fan.
10. Avoid the use of gasoline, benzene, thinner etc as they may result in damage to the fan.
11. Store the fan in a clean dry place when not in use.