Cleaning And Maintenance; Service Centre - Probuilder 99008 Instruction Manual

4. Push a bolt (6) into the rail, as shown in
the drawing.
Attach the saw onto the mitre saw stand
so that the four bolts go through the
mounting holds in the saw's base plate.
Place a washer, a spring washer and a nut
on each bolt and tighten the nuts to fully
secure the saw to the rails.
5. The mitre saw stand is now assembled
and ready for use.

Cleaning and maintenance

Check regularly that all nuts and bolts are
tightened properly.
Use a brush to remove any �lings and dirt
from the mitre saw stand.
Stubborn dirt can be removed using a well-
wrung cloth.
The mitre saw stand must not be washed or
high-pressure washed.
Regularly lubricate all bolts and nuts using
acid-free oil or lubricating spray.
Fold the mitre saw stand up and store it in a
dry, dust-free location indoors when it is not
in use.

Service centre

Note: Please quote the product model
number in connection with all inquiries.
The model number is shown on the front of
this manual and on the product rating plate.
For:
• Complaints
• Replacement parts
• Returns
• Guarantee issues
• www.schou.com
Manufactured in P.R.C.
Manufacturer:
Schou Company A/S
Nordager 31
DK-6000 Kolding
All rights reserved. The content of this manual may not
be reproduced, either in full or in part, in any way by
electronic or mechanical means, e.g. photocopying or
publication, translated or saved in an information storage
and retrieval system without written permission from
Schou Company A/S.
GB
21