BTECH GMRS-PRO Operate Manual

GMRS-PRO Operate Manual
FCC Statement:
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates ,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures::
—Reorient or relocate the receiving antenna .
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC SAR
SAR tests are conducted using standard operating positions accepted b y the FCC with the
device transmitting at its highest certified power level inall tested frequency bansd,
although the SAR is determined at the highestcertified power level, the actual SAR level of
the device while operatingcan be well below the maximum value Before a new device
is a availablefor sale to the public, it must be tested and certified to the FCC that itdoes not
exceed the exposure limit established by the FCC, Tests for eachdevice are performed in positions
and locations as required by the FCC.
This radio complies w it h exposure limit s for General Populat ion/Uncont ronlled RF exposure
environment at operat ing dut y fact ors of up t o 50% .
For face-up,25mm was used for test, this equipment should be installed and operated with minimum
distance 25mm.
Non‐compliance with the above restrictions may result in violation of
RF exposure guidelines.