Verifying The Version; Test Mode - Roland CUBE-STEX Service Notes

Table of Contents

Advertisement

Apr. 2014
ACCESSORIES (Standard)
5100010587
5100009481
5100012740
5100009482
5100009486
5100009484
5100009483
5100009485
5100031008
#
5100038579
#
5100038582
#
5100038578

Verifying the Version

Items Required
• Foot switch (FS-5U x 2 or FS-6 x 1)
* Set the POLARITY switch and the MODE switch on the foot switch as shown
below.
fig.FS-5U.eps
fig.FS-6.eps
• Foot-switch connection cable (PCS-31 or PCS-33)
Procedure
1.
Connect a foot switch to the FOOT SW MIC/GUITAR jack.
* If you're using a PCS-31 cable, white is for tip and red is for ring. If you're
using a PCS-33 cable, the pedal connected to B on the FS-6 is for tip and the
pedal connected to A is for ring. Also check the panel indication on the FS-6.
2.
Make the following settings on the main unit.
• POWER:
OFF
• INPUT SELECT:
MIC
• OUTPUT POWER: ECO
• STEREO LINK:
Left side (LINE OUT side)
• All controls:
Minimum
(Turn the controls all the way counterclockwise.)
3.
Hold down the ring section of the foot switch connected to the FOOT SW
MIC/GUITAR jack and switch on the power.
All LEDs light up.
* Continue to hold down the foot switch.
AC ADAPTOR
AC CORD 100V 1.0M
AC CORD
AC CORD
AC CORD
AC CORD
AC CORD 181-AP009-G
AC CORD
4POLES MINI CABLE
OWNER'S MANUAL
OWNER'S MANUAL
OWNER'S MANUAL
FS-5U
FS-6
PSB-12U
181-AP009-J 3-230202-024266
181-AP009-BL 117VBL 1.0M
181-AP009-UC 117V 1.0M
181-AP009-CN 220VCN 1.0M
181-AP009-B 230VE
181-AP009-G 230V EU 1.0M
181-AP009-A 240VA 1.0M
452-12020-01-00
JAPANESE
MULTILANGUAGE
CHINESE
4.
After all LEDs have lighted up and then flashed once, within 2 seconds,
depress first the ring section and then the tip section of the foot switch.
All LEDs flash rapidly several times, then the three LEDs at the center of
the panel indicate the software version, as described below.
* In this document, the three LEDs at the center of the panel are called LEFT,
CENTER, and RIGHT.
fig.tuner-led.eps
Version
LEFT
1.00
*
1.01
-
1.02
-
1.03
*
1.04
*
1.05
-
*: flashes, -: goes off
5.
Switch off the power to the unit.

Test Mode

Items Required
• Foot switch (FS-5U x 2 or FS-6 x 1)
• Foot-switch connection cable (PCS-31 or PCS-33)
• 1/4-inch phone plug
• Miniature stereo phone plug
Entering the Test Mode
1.
Go to Verifying the Version (p. 23) and execute steps 1 through 4.
2.
Depress the tip section of the foot switch connected to the FOOT SW
MIC/GUITAR jack to enter the first test item, DSP/EEPROM Test (p. 24).
Quitting the Test Mode
Switch off the power.
Skipping Test Items
Test items cannot be skipped.
CUBE-STEX
for 100V
for 117VBL
for 117VU, 117VU/CS
for 220VCN
for 230VE
for 230VEU
for 240VA
CENTER
RIGHT
-
-
*
-
-
*
*
-
-
*
*
*
1
1
1
1
1
1
1
1
1
1
1
1
23

Advertisement

Table of Contents
loading

Table of Contents