Download Print this page

Fortress Technologies FW1016B813 User Manual page 18

Advertisement

Spin
Appears at the beginning of the final spin step and remains lit during Spin+Drain special programmes.
If the washer does not pass to the spinning step, the automatic unbalanced load detection system might
be activated due to the unbalanced distribution of the laundry in the washer.
Loading door lock
There is a locking system on the loading door of the washer that prevents opening of the door in cases when the
water level is unsuitable. Door Locked symbol appears when the loading door is locked. This symbol will flash
until the programme completes or the washer is paused. Do not force to open the loading door in this step.
Symbol will disappear when the door is ready to open. Open the door when the symbol disappears.
Changing the selections after programme has started
Switching the washer to pause mode
Press the Start / Pause button to switch the washer to pause mode. Pause symbol will appear on the display
indicating that the appliance is paused. Start symbol will disappear.
Changing the speed and temperature settings for auxiliary functions
Depending on the step the programme has reached, you may cancel or activate the auxiliary functions, see
"Auxiliary function selection". You may also change the speed and temperature settings, see "Spin speed
selection" and "Temperature selection".
Adding or taking out laundry
Press the Start / Pause button to switch the washer pause mode. The programme indicator of the relevant step
during which the washer was switched into the pause mode will flash. Wait until the loading door can be opened.
Open the loading door and add or take out the laundry. Close the loading door. Make changes in auxiliary
functions, temperature and speed settings if necessary. Press Start / Pause button to start the washer.
The loading door will not open if the water temperature in the washer is high or the water level is
above the door opening.
Child lock
Use Child Lock function to prevent children from tampering with the appliance. Thus any changes in a running
programme can be avoided.
The washer can be switched on/off when the Child Lock is active. When the washer is switched on
again, programme will be resumed from where it has stopped.
To activate the Child Lock:
Press and hold the second and the forth Auxiliary Function buttons for 3 seconds. "CON" will appear on the
display.
Same phrase will appear on the display if press any buttons when Child Lock is activated.
To deactivate the Child Lock:
Press and hold the second and the forth Auxiliary Function buttons for 3 seconds. "COFF" will appear on the
display.
Do not forget to disable the Child Lock at the end of the programme if it was activated before.
Otherwise, washer will not allow to select a new programme.
16

Advertisement

loading