Related Manuals for Fortress Technologies FFW812C11E
Summary of Contents for Fortress Technologies FFW812C11E
- Page 1 Washing Machine FFW812C11E FFW1012C11E FFW1212C11E USER’S MANUAL Please read the manual before using the product and please take good care of it.
- Page 2 Please read this manual first! Dear Customer, We hope that your product which has been manufactured in modern facilities and passed through a strict quality control procedure will give you the best results. Therefore ,we advise you to read through this manual carefully before using your product and keep it for future reference.
-
Page 3: Table Of Contents
TABLE OF CONTENTS 1 Your Washing Machine Auxiliary functions c i f o i t Starting the program Progress of program 2 Warnings Changing the selections after the program has started Child lock Ending the program through cancelling Safety instructions If there are children in your house... - Page 4 Overview Figure 1 Top Lid Adjustable Feet Detergent Drawer Door Control Panel Filter Cap...
- Page 5 Specifications FFW812C11E FFW1012C11E FFW1212C11E Model Maximum washing capacity (kg) Height (cm) 59.7 59.7 59.7 Width (cm) 56.5 56.5 56.5 Depth (cm) Net Weight (kg) Electricity (V/Hz.) 220-240V~ 50H z 220-240V~ 50H z 220-240V~ 50H z Total Current (A) 2000-2350W 2000-2350W...
-
Page 6: Your Washing Machine
Warnings Please read the following information. for 3 seconds to cancel the program Otherwise, there may be the risk of set in your machine． If the problems personal injury or material damage. cannot release, please contact the Moreover, any warranty and reliability authorized service. -
Page 7: Safety Instructions
companies that produce detergents If there are children in your for your machine. house... ‡ Electrical appliances may be Safety instructions dangerous for children. Keep ‡ This appliance must be connected children away from the machine to an earthed outlet protected by a when it is operating. -
Page 8: Installation
Installation 3. Fit the covers (supplied in the bag Removing packaging with the Operation Manual) into the reinforcement holes on the rear panel. (“P”) Tilt the machine to remove the packaging reinforcement. Remove the packaging reinforcement by pulling the ribbon. Keep the transportation safety bolts in a safe place for reuse when the washing machine needs to be... -
Page 9: Connecting To The Water Supply
3. Important: Tighten all locknuts up check if there is any water leakage again. at the connection points. Turn off the tap and remove the nut in case of any leakage. Retighten the nut carefully after checking the seal. Connecting to the water supply. -
Page 10: Electrical Connection
Electrical connection ‡ In case the hose is elevated Connect the machine to an earthed after laying it on the floor level or outlet protected by a fuse of suitable close to the ground (less than capacity. Important: ‡ Connection should comply with national regulations. -
Page 11: Initial Preparations For Washing
Initial preparations for washing Sorting the laundry ‡ Empty pockets and remove all ‡ Sort the laundry according to type foreign objects such as coins, pens of fabric, color, and degree of soiling and paper clips. If possible, turn and permissible water temperature. pockets out and brush. -
Page 12: Detergents And Softeners
Following weights are given as examples. Detergent, softener and other cleaning agents Laundry type Weight (gr.) Add detergent and softener before Bathrobe 1200 starting the washing program. Napkin Never open the detergent dispenser Duvet cover drawer while the washing program is Bed Sheet running! When using a program without pre-... - Page 13 Softener Put the softener into the softener compartment of the detergent dispenser. ‡ Use the proportions recommended on the package ‡ Never exceed the (> max <) level marking; otherwise, the softener will be wasted. ‡ If the softener has soildified dilute the densed softener with water before placing it in the detergent drawer.
- Page 14 Prewash Quick Wash Rinse Plus Anti Creasing Display 15 - Child lock...
-
Page 15: Display Symbols
Display symbols Figure 3 appear. Press "Start/Pause/Cancel" button (Figure 2-10) to start the program. Main programs Depending on the type of textile, the following main programs are available: •Cotton 13.a - Spin Speed Indicator You can wash your durable clothes 13.b –... -
Page 16: Additional Programs
and the permissible water temperature when you choose which program to use. • Delicate You can wash your delicate clothes with this program. It has sensitive washing movements and does not make intermediate spinning compared t “Synthetic” program. As “Intensive”and“Intensive+”programs are long programs with higher temperature washing mesh structure fabrics may produce large amounts... -
Page 17: Spin Speed Selection
the auxiliary temperature appears on the temperature indicator (13b). To adjust the temperature, press the temperature button (Figure 2-9). Temperature falls with 10° decrements. Cold selection is shown with “-” symbol. When the “Temperature” button is No pin is shown with “ ”... -
Page 18: Program Selection And Consumption Table
Program selection and consumption table Programme (°C) Intensive+ Eco 40 Quick Quick Quick ‡ Selectable * Automatically selected, not cancellable. Water and power consumption and programme duration may various from the table shown, subject to changes in water pressure, water hardness and temperature, ambient temperature, type and amount of laundry, selection of auxiliary functions, and fluctuations in the supply voltage. -
Page 19: Auxiliary Functions
recommended for veils and curtains. Auxiliary functions Quick wash Auxiliary function selection keys With this program (11b), the wash time is shortened. “F2” symbol will light up on the display. ‡ Use this function for smaller amounts or slightly soiled laundries. Rinse plus This function (11c) allows your machine to perform an extra rinsing in addition... -
Page 20: Starting The Program
(Figure 3-13h) will light up. Standby type and amount of laundry, auxiliary symbol (Figure 3-13k) will fade. Start functions selected, and changes in symbol (Figure 3-13j) will light up. the supply voltage. 4. The “:” in the middle of the displayed Time delay time delay will start flashing. -
Page 21: Changing The Selections After The Program Has Started
mode lights up and the start symbol step that is being carried out. (Figure 3- 13j) that shows the program has Prewash started and still continuing fades out. When “Prewash” auxiliary function is Selecting or canceling an auxiliary selected, prewash symbol will light up to function in standby mode indicate the beginning of prewash step. -
Page 22: Ending The Program Through Cancelling 2
on the screen whenever any button without spinning: is pressed while the machine is child- Press “Start/Pause/Cancel” button locked. (Figure 2-10). The tandby symbol To deactivate the child-proof lock, (Figure 3-13k) will fade. The tart symbol press the 2nd and 4th auxiliary function (Figure 3-13j) will light up. -
Page 23: Quick Instructions For Daily Use
Quick instructions for daily use Preparation program starts). At the beginning 1. Turn the tap on completely. Check if of a washing cycle (machine allows the hoses are connected tightly. adding more laundry during a future 2. Place the laundry in the machine. step only if the water level is low 3. -
Page 24: After The Program Is Finished
P DFKL Q HIRU D EDO DQ FHG O RDG 6HO HFW W KHVSL Q SU RJU DP $GM XVW W KHVSL Q VSHHG After the program is finished 3U RJU DP L Q GL FDW RU V\ P ERO V ) L JXU H I RQ W KHVFU HHQ Z L O O U HP DL Q O L W DIW HU W KHSU RJU DP L V IL Q L VKHG ¥( Q Gµ... -
Page 25: Cleaning And Care
Cleaning and care Detergent drawer Remove any powder residue buildup in the drawer. To do this; 1. Press the dotted point on the siphon in the softener compartment and pull towards you until the compartment is removed from the machine. Outer cabinet and control panel When necessary:... -
Page 26: Draining Any Remaining Water And Cleaning The Pump Filter
‡ Remove the nuts of the water intake hoses to clean the surfaces of the filters on the water intake valves with an appropriate brush. ‡ If the filters are very dirty, you can pull them out by means of pliers and clean them. - Page 27 hose and fit the hose back into its place. If your product is not supplied with an emergency drain hose, do the following as shown in the figure below: ‡ Place a large container in front of the filter to receive water flowing from the filter.
-
Page 28: Troubleshooting
Troubleshooting Problem Cause Explanation / Suggestion Machine may have Program switched to self Reset your machine by pressing “Start/Pause/ cannot be protection mode due to Cancel” button for 3 seconds. (see, Cancelling started or an infrastructure problem a Program) selected. (such as line voltage, water pressure, etc.). - Page 29 The water being taken Improper position of the Connect the water draining hose as described in is directly drain hose. in the operation manual. discharged. No water can This is not a problem. The be seen in water level is not visible the machine from the outside of the during...
- Page 30 In the case of a paused countdown while taking in The machine will wait and operate until there is water: filled with sufficient amount of water to avoid Timer will not countdown poor washing results due to lack of water. until the machine is filled Then the timer will start to count down.
- Page 31 - Using insufficient amount of detergent for a long time, - Use the recommended amount of detergent - Washing at low appropriate for water hardness and the laundry. Washing temperatures for a long - Select the proper temperature for the laundry performance is time, to be washed.
- Page 32 The amount, brand and storage conditions of the Store detergent in a closed and dry place. Do detergent used might not not keep them under high temperatures. be appropriate. If detergent is filled in the prewash compartment Detergent might have although prewash cycle is not selected, the been filled in the wrong machine can take this detergent during rinsing...
- Page 33 Detergent may have been Dry the detergent drawer before putting in filled in wet dispenser detergent. drawer. Detergent may have Store detergent in a closed and dry place. Do gotten damp. not keep them under high temperatures. Detergent Water pressure might be residue in the dispensing The detergent in the main...
- Page 34 The plug might not be plugged in the mains Check the plug. outlet. Fuse may have operated. Check the fuse. Machine does not work. Nothing is displayed on Electricity may be cut Check the supply power. the screen. off. The “On/Off” button might have not been Press this button.
- Page 35 ALL REQUESTS FOR SERVICE SHOULD BE MADE TO : FORTRESS SERVICE DEPARTMENT FORTRESS Fortress Service Centre hotline, Tel: 2555-5788...
Need help?
Do you have a question about the FFW812C11E and is the answer not in the manual?
Questions and answers