Mounting The Table Machine; Mounting The Workpiece Support; Use; Adjusting Workpiece Supports - Parkside PUG 1600 B2 Original Instructions Manual

4. Push the machine support quick-release
lever towards the base frame to lock
into position.
5. Reverse this procedure to dismantle.

Mounting the table machine

Mounting the table machine
on the machine supports
1. Pull the machine support quick-release
levers (8) upwards to unlock.
2. Adjust the distance between the ma-
chine supports (2) to correspond with
the mounting holes on the table ma-
chine.
3. Push the machine support quick-release
lever towards the base frame to lock
into position.
4. From below, insert one of the four long
bolts (12) through the machine sup-
port. Secure the table machine to the
machine support with a spring washer
(15), a flat washer (16) and then a nut
(14). Use the supplied spanner (11) to
tighten the bolts.
If the mounting holes of your table
machine do not fit the machine sup-
ports, mount the machine support profiles.
Mounting the machine
support profile
1. Place the machine support profiles (3)
on the machine supports (2).
2. From below, insert one of the four short
bolts (13) on the right and left through
the machine support profile. Fasten the
machine support profile to the machine
support with a spring washer (15), a
washer (16) and then a nut (14).
Use the supplied spanner (11) to tight-
en the bolts.
Tighten the bolts firmly.
Mounting the table machine
on the machine support
profile
1. Adjust the distance between the ma-
chine support profiles (3) to correspond
with the mounting holes on the table
machine.
2. From below, insert one of the four long
bolts (12) through the machine support
profile. Secure the table machine to the
machine support profile with a spring
washer (15), a flat washer (16) and
then a nut (14). Use the supplied span-
ner (11) to tighten the bolts.
Mounting the workpiece
support
1. Insert the workpiece support (1) into
the holder on the base frame.
2. Fix the workpiece support from behind
with a star grip screw (5).

Use

Adjusting workpiece
supports
Adjusting the height
1. Loosen the star grip screws (5) and set
the desired height.
The workpiece support should be at
the same height as the support surface
of your mounted table machine.
To ensure that your workpiece is
stable, do not pull out the work-
piece support beyond the max. marking.
2. Retighten the star grip screws to fix the
height.
Adjusting the length
1. Loosen the star grip screws (6).
This step is omitted for initial installa-
tion
GB IE
15