7.
Disconnect the cables from the reverse ZIF connectors on the board (3).
8.
Remove the three Phillips M2.0 × 2.5 screws (4) that secure the board.
9.
Remove the board from the computer (5).
NOTE:
Models with WWAN shown.
To install the USB board, reverse this procedure.
Lock bracket
To remove the lock bracket, use this procedure and illustration.
Table 5-10
Lock bracket description and part number
Description
Lock bracket (available in the Bracket Kit)
Before removing the lock bracket, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
4.
Remove the USB board bracket (see
Remove the lock bracket:
1.
Remove the Phillips M2.0 × 2.5 screw (1) that secures the bracket to the computer.
Preparation for disassembly on page
Bottom cover on page
28).
USB board on page
Battery on page
30).
39).
Spare part number
N18576-001
28).
Lock bracket
41