Advertisement
Available languages
Available languages
Handle - Two handles are designed on both
ends of the middle cover. When moving the Product, li! the end opposite of the castor, grasp the handle and move the Pro d
EN
Before cleaning, ensure the power switch is turned off, and the attaching plug is pulled out of the socket.
The rubber pedal and covers can be cleaned with a wet cloth containing detergent, and the detergent
should be removed with a cloth.
!
NOTICE: Do not clean the product with corrosive detergent such as benzene or thinner, as it may
cause fading, corrosion or crack on the Product. Do not splash water into the product to avoid
short circuit.
CONTROLLER
As wet cloth may cause malfunction of the controller, only dry cloth can be used.
Storage and maintenance
Make sure that the power switch is turned off and the plug is removed from the power supply
Clean off the dust and dirt on the Product and keep it clean and away from places with high
temperatueę or high humidity.
If the Product is not in use for a long period, a dustproof cover (but it yorself) should be applied on the
Pro- duct to prevent the entry of dust.
Common problems & Solutions
1. Emergency stop: Led on console shows '' Er-3", Led on PCB flashes three Times.
2. Connection error: Led on console shows ''ER-4", Led on PCB flashes four Times.
3. Electron power tube demage: Led on console shows ''ER-5", Led on PCB flashes five Times.
4. Current Overload: Led on console shows ''ER-6", Led on PCB flashes six Times.
5. Engineer abnormality: Led on console shows ''ER-7", Led on PCB flashes seven Times.
6. Blocked Engineer: Led on console shows ''ER-8", Led on PCB flashes eight Times.
7. Low voltage: Led on console shows „ER-9", Led on PCB flashes nine Times.
Technical specyfication
Rated voltage: 220-240 VAC 100-120
VAC Rated power: 200 W
Rated frequency: 50/60 Hz
Maximum user weight: 150 kg
Moving method
Storage
and maintenance surface cleaning
Handle
Advertisement
