Page 3
Thanks for choosing Ninebyfour. Since we’ve pre-assembled the lamps, installing them is done in a few simple steps. Design by Waarmakers...
Page 4
1013 DK Amsterdam The Netherlands +31 20 261 76 68 info@waarmakers.nl store.waarmakers.nl Product : LED Tubelight luminary Model / Type : NinebyFour / Johannes Verhulst st Power : 220V Production year : 2017 Y IJA IE IA Conform European guidelines:...
DO NOT CONNECT THIS SIDE TO POWER SAFETY INSTRUCTIONS As you unpack and prepare for assembly, Use a damp cloth, never a strong cleaning place the contents on a carpeted or padded agent. Do not immerse in water. area to protect them from damage. Note: 2 people are required to safely install To maintain the wood in best condition, oil this product.
Mounting on ceiling Step A. Screw in both eye-bolts in the ceiling. Use appropriate mounting method for your ceiling. (plugs not included) Step B. Guide the cotton cord through the hooks. Step C. Guide the cotton cord through the holes in the wooden fixture.
Step E. Levelling: This is, and obviously so, a natural material. It might occur that the lamp is not perfectly horizontal the first try. To adjust, turn the knot in step 3. (bottom right of this page) a half or a quarter turn. This might take a little tinkering.
Mounting on wall Step A. Drill holes at a distance of 650mm and insert plugs into holes in wall (not included). Step B. Remove cork-stop from lamp, then carefully remove the led tube. Step C. Place the bolts through the wooden light-fixture and optional place the spacers (not included) over the ends of the bolts.
Page 12
Replacing the LED tube 1. Shut off the electrical power. click! 2. Pull out cork b1. from the fixture end B. 3. Take out the LED tube by carefully pulling at powered end while stopping the fitting from coming out of the hole (side C). 4.