Page 1
Waarmakers Thank you for purchasing this Ninebyfour lamp. This document lists all the contents included in the box and instructions for installation. As you unpack and prepare for assembly, place the contents on a carpeted or padded area to protect them from damage.
Page 2
Philips Led Tube This page is not an assembly step for Ninebyfour. This information is specific for the Philips Led tube used in the Ninebyfour lamp. IMPORTANT Product is not dimmable. Always switch off power supply before installing Only apply in dry indoor usage and environments.
Page 3
12x7 mm + hole 4.5 mm lamp stopper 2x conical cork 32.5x28.5x27mm cable + plug 1x red cloth wire + 1x plug stopper cork philips LED tube Pendant cord kit height adjusting system wood (same tree) 82x10x12mm cord 2mm waxed cotton store.waarmakers.nl...
This is, and obviously so, a natural material. It might occur that the lamp is not perfectly horizontal the first try. To adjust, turn the knot in step 3. (bottom right of this page) a half or a quarter turn. This might take a little tinkering. store.waarmakers.nl...
Step 1. Clamp the wooden pen at the bottom end on the cotton cord. Step 2. Wrap the cord around the pen until reaching the desired height. Step 3. Fix the cord by clamping the cord in the top end op the wooden pen. store.waarmakers.nl...
Power cord Remove plug if installing power cord on the ceiling. If needed, use extra eye-bolt to hold the excess length of power cord (situation A.) store.waarmakers.nl...
Align the light-fixture against the wall by fixing the bolts inside the wall. Step D. With the lamp mounted, place the led-tube back in the fixture and close with cork-stop. Step E. Plug in the light to turn on. store.waarmakers.nl...