Saxby 13822 Instruction Manual

Wiring
Having correctly identified the wiring from your existing light fitting, pull the mains wire through the conduit and connect to the
terminal block in the following way:
SUPPLY
NEUTRAL
EARTH (GREEN/YELLOW)
SWITCHED LIVE
Fitting/Replacing the bulb: Max. 60W E27 GLS
When changing a bulb, always switch off at the mains and allow the bulb to cool before
handling. Dispose of used bulbs carefully and responsibly. Use a soft cloth to handle bulbs,
avoid directly touching the bulbs as this will shorten their life.
Do not exceed the wattage stated or use a different shape bulb from that indicated on the fitting.
Technical data
Bulb
Supply
220-240V~, 50Hz 1 x Max. 60W E27 GLS (required)
Voltage: Type:
Conformity with all relevant UKCA Directive requirements.
Conformity with all relevant EC Directive requirements.
This is a Class 1 product and must be earthed.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or local store for recycling advice.
This product is rated at IP65
65
IP
This product is not suitable for dimming.
Care and Safety
Allow 10 minutes to cool before replacing, adjusting or cleaning.
We recommend cleaning with a soft dry cloth. Do not use solvents or abrasive cleaners as these could damage the finish.
For your safety, always switch off the power supply before changing lightbulbs, or cleaning.
The bulb source is protected by the shade. The shade must be replaced immediately should it
become cracked or damaged. This fitting must not be used without the shade in place.
Replace Cracked Shade
V3 19/05/2022
UK Manufacturer: BH17 7BY
EU Manufacturer: Brilliant AG,
Brilliantstrasse 1, D-27442 Gnarrenburg
LIGHT FITTING
BLUE (N)
Check that...
GREEN/YELLOW You have correctly identified the wires.
The connections are tight.
BROWN (L) No loose strands have been left out of
the connection block.
Max. 60W E27
Instruction manual
Zone Bollard
13822
www.saxbylighting.com
80775 Root Kit