Table of Contents
Advertisement
Quick Links
Commissioning
• Place the light fitting over the threads of the securing
Screws and refit the rubber washers and finials to
secure. Make sure the fitting is correctly oriented in a
PIR Adjustment
1. The unit must be installed in a vertical position, and
fitted 1.8m - 2.5m above the ground.
2. The detection angle is set at 130 degrees and the
detection distance is 8m. The PIR will start activating
when the light level drops to 20 LUX and will continue
to activate until the light level rises to 2000 LUX.
When adjusting the sensitivity (detection distance)
Either side of product
Left
Side
Fitting/replacing bulbs
• The LED bulbs in this product are non replaceable
We recommend cleaning with a soft dry cloth.
Do not use solvents or abrasive cleaners as these could
damage the finish.
Recycling advice
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Safety information
Live Voltages may be present in this unit even when turned off or when completely disconnected. For your safety,
always switch off the supply before changing lightbulbs, or cleaning.
www.saxbylighting.com
vertical direction (See Fig. 2 overleaf).
• Replace fuse or circuit breaker and switch on. Your
light is now ready for use.
in daylight it will be necessary to cover the sensor
to simulate night time. When the PIR is activated the
light will remain lit for a maximum of 5 minutes. The
minimum is 5 seconds.
Right
Side
Iss.4 22012016
Saxby Lighting Ltd. BH23 3PE
Instruction leaflet
Evesham Wall
54555, 54556
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Saxby Evesham Wall
Summary of Contents for Saxby Evesham Wall
- Page 1 • Place the light fitting over the threads of the securing vertical direction (See Fig. 2 overleaf). screws and refit the rubber washers and finials to • Replace fuse or circuit breaker and switch on. Your secure. Make sure the fitting is correctly oriented in a light is now ready for use. Evesham Wall PIR Adjustment 1. The unit must be installed in a vertical position, and in daylight it will be necessary to cover the sensor 54555, 54556 fitted 1.8m - 2.5m above the ground.
- Page 2 Installation Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and satisfactory operation of this product. Please retain these instructions for future reference. Existing fittings must be completely removed before surfaces use appropriate fixings). Feed the incoming installation of a new product. Before removing the mains supply cable through the grommet entry existing fitting, carefully note the position of each set hole. Fix the wall back to the wall using the supplied Warning of wires. screws (See Fig. 1). • The help of an assistant is recommended when • Wire as detailed below. This product is Class 2 (Double insulated) If replacing an existing fitting, make a careful note of installing this fitting. and must not be earthed. the connections.
Need help?
Do you have a question about the Evesham Wall and is the answer not in the manual?
Questions and answers