Download Print this page

Saxby EL- 40075 Instruction Leaflet

Tribeca post and bollard

Download this manual

Commissioning

• Push the terminal block up into the tube.

• Stand the product in place inline over the mounting holes

and use a suitably sized screwdriver to tighten the screws

so that they hold the fitting securely to the mounting

surface.

• Replace fuse or circuit breaker and switch on. Your light

is now ready for use.

Fitting/replacing bulbs

• The LED's in this product are non replaceable.

We recommend cleaning with a soft dry cloth.

Do not use solvents or abrasive cleaners as these could

damage the finish.

Recycling advice

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.

Check with your Local Authority or retailer for recycling advice.

Safety information

For your safety, always switch off the supply before changing lightbulbs, or cleaning.

If any part of the (LED) housing is broken or cracked then it cannot be replaced and the fittings must not be used - as the

water ingress protection has been compromised.

www.saxbylighting.com

Instruction leaflet

Tribeca Post and Bollard

EL- 40075, EL- 40076

Iss.2 20150717

Saxby Lighting Ltd. LS9 0SE

Need help?

Do you have a question about the EL- 40075 and is the answer not in the manual?

Page 1 Tribeca Post and Bollard and use a suitably sized screwdriver to tighten the screws so that they hold the fitting securely to the mounting surface. EL- 40075, EL- 40076 • Replace fuse or circuit breaker and switch on. Your light is now ready for use. Fitting/replacing bulbs • The LED's in this product are non replaceable.
Page 2 Installation Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and satisfactory operation of this product. Please retain these instructions for future reference. Existing fittings must be completely removed before • This product comes complete with screw and rawl plugs installation of a new product. Before removing the existing which are suitable for use on most surfaces, however fitting, carefully note the position of each set of wires. alternative fixings may be required.

El- 40076