Summary of Contents for Chamberlain GAROG DK Series
- Page 1 OPERATING MANUAL INDUSTRIAL DOOR DRIVES DK/DKA-SERIES Serial nummer: 2 YEAR WARRANTY (see motor gearbox) Installed on: Switchgear standart:...
-
Page 2: Table Of Contents
TABLE OF CONTENTS TABLE OF CONTENTS PAGE TECHNICAL DATA PAGE DK / DKS DRIVES IMPORTANT SAFETY ADVICE 3 - 4 DIMENSIONAL DRAWINGS GENERAL INFORMATION DK / DKS DRIVES TECHNICAL DATA PREPARATORY TASKS DKA DRIVES INSTALLATION ADVICE DIMENSIONAL DRAWINGS DKA DRIVES 1.1 MOUNTING ARRANGEMENT INSTALLATION ADVICE DIMENSIONAL DRAWINGS... -
Page 3: Important Safety Advice
IMPORTANT SAFETY INFORMATION Before installation, operation or maintenance of this door drive, this operating manual must be read through carefully and all the safety advice must be followed. This symbol means "Caution" and stands in front of safety advice intended to avoid personal injury or material damage. -
Page 4: General Information
Every geared motor is manufactured according to the valid technical documentation and subjected to a test run at Chamberlain. We retain the right to make changes to technical data and design, which are in the interests of progress. Dispatch takes place in the appropriate packaging. -
Page 5: Preparatory Tasks
PREPARATORY MEASURES The drive may only be installed: If the details on the rating plate on the drive correspond with the mains voltage. If the drive is undamaged If the ambient temperature is between 0 and 40°C If the installation height is not more than 1000m above sea level If the type of protection has been appropriately selected. -
Page 6: Mounting Arrangement
MOUNTING ARRANGEMENT Mounting arrangement 1 Mounting arrangement 2 INSTALLATION ADVICE Electrical connection The connections according to the circuit diagram and the maintenance of the electrical drive may only be carried out by electrical specialist personnel. The corresponding accident prevention regulations must be followed. For switching the motor and the brake connections, switching contacts of utilization category AC-3 acc. -
Page 7: Electrical Connection
If they are not heeded serious injuries or damage to the drive can occur. The control housing of the door drive may only be opened by trained"Chamberlain" specialist personnel. If necessary please contact your local Chamberlain dealer. -
Page 8: Nec Limit Switch With Illustration
NEC LIMIT SWITCH WITH ILLUSTRATION Limit switch setting: The limit switch is delivered in a non-adjusted state. It has two all-purpose cams which each consist of an operating limit switch and a safety limit switch (black and yellow cams) and potential-free contacts (grey, white and blue cams). -
Page 9: Cam Limit Switch With
CAM LIMIT SWITCH WITH CONNECTING TERMINAL STRIP Redundant safety devices are self-monitoring, i.e. they can detect an error within the circuit and in the device connections. This type of circuit requires the use of self- monitoring sensing equipment. Safety contact for emergency Supplementary chain / crank... -
Page 10: Circuit Diagrams Sts1 / Nec/Motor
CIRCUIT DIAGRAM STS1 / NEC / MOTOR Black Light blue Brown Yellow Green 230V, 3 phase feed Black Light blue Brown Yellow Green 400V, 3 phase feed... -
Page 11: Circuit Diagram Sts1
Redundant safety devices are self-monitoring, i.e. they can detect an error within the circuit and in the device connections. This type of circuit requires the use of self-monitoring sensing equipment. Jumper J1 bridged over = Self-latching upward travel Garog DK series door drive with STS1 controller VOLTAGE INCORRECT VOLTAGE... -
Page 12: Cam Limit Switch With Connecting Terminal Strip + Tst2 Controls
CAM LIMIT SWITCH WITH CONNECTING TERMINAL STRIP + TST2 CONTROLS... -
Page 13: Circuit Diagram Ews2T/Tst1
CIRCUIT DIAGRAM EWS2T/TST1... - Page 14 TECHNICAL DATA - DK / DKS DRIVES Chamberlain Garog base set drives include the ready wired door drive with a potential-free cam limit switch (NE) or a 24V contactor controller (STS) with cam limit switch (NEC). Various types of emergency actuators are available: The short emergency crank handle (NHK), the automatic emergency chain (NKU) as well as the quick-action clutch (DKS).
- Page 15 DIMENSIONAL DRAWINGS DK / DKS DRIVES DK...NKU Fig. 1 4xM10, depth 20, both sides ª DK...NHK 4xM10, depth 20, both sides ª 96,5 231.5 4xM10, depth 20, both sides ª 96,5...
-
Page 16: Technical Data Page
CIRCUIT DIAGRAM: SEK Chamberlain Garog base set drives include the ready wired door drive with a potential-free cam limit switch (NE) or a 24V contactor controller (STS) with cam limit switch (NEC). Various types of emergency actuators are available: The short emergency crank handle (NHK), the automatic emergency chain (NKU) as well as the quick-action clutch (DKS). -
Page 17: Dimensional Drawings Dka Drives 1.2
DIMENSIONAL DRAWINGS DKA DRIVES 1.2 Section 2 Fig. 3 B4 ... B5 Bracket type OKD5-8 Torque angle DW1 to DW3 Drive dimensions (in mm) Drive type: Fig. 4 Space requirement to lift cover ª Articulated food - article G-GF do not use for DKA120... -
Page 18: Corner Brackets
DIMENSIONAL DRAWINGS - ANGLE BRACKETS / UNIVERSAL BRACKETS Fig. 5 Angle brackets: WK3L or 3R / WK4L or 4R / WK5L or 5R WK angle brackets Bracket Material Door Article no. type: thickness weight for DKA 120 Fig. 6 B4...B5 45,5 OKD universal brackets with bearings Door... -
Page 19: Welded Axes
DIMENSIONAL DRAWINGS - WELDED AXES / SET COLLARS Fig. 7 Welded axes / set collars M100 b x h Welded axes and set collars Axis Dia. d w x h Article no. none Bearing side Drive side none Bearing side Drive side Both sides Set collar 30... -
Page 20: Maintenance Plan
If for whatever reason your drive does not operate as desired or not as is described in the operating manual, please first check whether you have read and correctly followed all the instructions. If faults are still occurring please make contact with your local Chamberlain dealer who will be happy to support you in rectifying the fault. -
Page 21: Warrenty
GUARANTEE AND STORAGE Definition of qualified personnel Within the meaning of the operating manual and the warning information concerning the product itself, these are people who are familiar with the setting out, installation, commissioning and operation of the product and have suitable qualifications for their work, such as: Training or instruction in, and authorization to connect up, switch on and off, earth and mark power circuits and devices according to the engineering safety standards. -
Page 22: Spareparts
SPARE PARTS The spare parts kits obtainable for your drive are given in the following parts lists. If your drive already has optional modifications and/or accessories, certain parts can be added or removed from the list. Possibly individual parts of a kit are not obtainable - please contact a member of staff responsible for spare parts and maintenance. -
Page 23: Notes
NOTES... - Page 24 Part number, description, model number IN NORTH AMERICA IN EUROPE ADDRESS FOR ORDERS: ADDRESS FOR ORDERS: The Chamberlain Group Inc. -GmbH Chamberlain Electronic Parts and Service Department Alfred-Nobel-Str. 4 66793 Saarwellingen 2301 N. Forbes Blvd., Suite 104 Tucson, Arizona 85745 USA TEL.