Riverside Furniture Corinne 21533 Assembly Instructions

Riverside
email: info@riverside-furniture.com
Components packed with the Dining Table TOP
Table Top Table Top Leaf
A 1 pc. B
Components and Hardware packed with the Dining Table BASE
Post Top Post Middle
C 4 pcs. D
Base Top Frame
G 1 pc.
Be sure to check all packing material carefully for small parts, which may have come loose inside the carton during shipment.
Separate, count and check all parts against the Components and Hardware List above. Failure to use the correct length bolts in
the proper locations may result in an unsafe product and could also cause damage to the parts being assembled.
ASSEMBLY STEPS:
1. Carefully place the Table Top (A) upside down on a clean, soft surface such as a blanket or carpet.
2. Attach the Base Top Frame (G) to the underneath side of the Table Top using the six 1-1/2" Long Allen-Head Bolts
(H), Spring Washers (J) and Flat Washers (K). Tighten with the Allen Wrench (L).
3. Attach each Post Top (C) into the corners of the Base Top Frame using two 2-1/4" Long Bolts (I), and the same
Washers as previous Step. Tighten with the Allen Wrench.
4. Position one Shelf (F) onto the bottom ends of the Post Tops and secure by attaching the Post Middle bolt through
the hole in each corner of the Shelf. Tighten hand tight.
5. Position the other Shelf onto the bottom ends of the Post Middles and secure using the Post Foot bolt through the
hole in each corner of the Shelf. Tighten hand tight.
6. Using two people, carefully lift the completed table and set upright.
7. To install or remove the Leaf, reach underneath the sides of the Table Top and unlock the catches. Pull the ends of
the Table Top apart, remove or add the leaf, slide the Table Top back together and re-lock the catches underneath.
Note: To prevent undue stress on the table and legs, if moving table, always use two people and carry the table from
one location to the other.
Corinne
Dining Room
FURNITURE
Assembly Instructions
1 pc.
Post Foot
4 pcs. E 4 pcs.
5/16 5/16
Long Allen-Head Long Allen-Head
Bolt Bolt
H 6 pcs.
I
STEP 1 & 2
G
Shelf
F 2 pcs.
5/16" x 12 x 3mm
Spring Washer
8 pcs. 14 pcs.
J
L
I
J
K
Page 1 of 2
Made in Viet Nam
21533 Gathering Ht. Dining Table TOP
21534 Gathering Ht. Dining Table BASE
21733 Gathering Ht. Dining Table TOP
21734 Gathering Ht. Dining Table BASE
5mm Allen Wrench
5/16" x 19 x 2mm
Flat Washer
14 pcs.
K L
STEP 3
C
1 pc.