Table of Contents
Advertisement
Available languages
Available languages
3. Check for Leaks
A. Turn on the hot and cold water supply valves under the sink.
B. Carefully inspect for leaks along ALL connections.
C. Tighten connections if leaks are found.
4. Electrical Supply Connections
WARNING
ELECTRICAL SHOCK HAZARD
Do not plug in the power cord until all steps are complete.
A. Make sure electrical power is disconnected at the fuse box or
circuit breaker box.
B. Remove access panel at the bottom of the dishwasher.
C. Remove the electrical junction box cover located behind the
access panel at the bottom of the dishwasher. The electrical
connection wiring for the dishwasher (BLACK and WHITE
wires) are located inside this junction box.
D. Locate the UL listed strain-relief bushing included in the
hardware kit. See Figure 1.
E. Remove the lock nut from the strain relief bushing. Push the
strain relief bushing into the round opening of the junction box
to stabilize the wiring. The lock nut should be installed on the
strain relief bushing inside the junction box. See Figure 5.
F. Insert the power cord (wire exposed) into the box through the
strain-relief bushing installed in step E.
G. To attach the grounding wire (identified by GREEN insulation
or bare wire) on the power cord:
Wrap the grounding wire around the grounding screw and
tighten OR,
Connect to ground wire in the junction box.
H. Connect the hot wire (identified by the BLACK or smooth
insulation) of the power cord to the black wire on the
dishwasher using the wire nut provided.
NOTE
Ensure all wire nuts are tight.
I. Connect the neutral wire of the power cord wire (identified by
the RIBBED insulation or WHITE insulator color) to the WHITE
wire on the dishwasher with the wire nut provided.
J. Tighten the strain-relief bushing screws and lock nut to
stabilize the power cord wiring. Check all connections to
ensure they are secure. Replace the junction box cover.
K. Restore electrical power at the fuse box or circuit breaker
box, then plug the power cord into the outlet.
L. Test for proper operation by running the dishwasher through
a fill, wash, and drain cycle. Inspect for leaks again (See step
3).
Advertisement
Table of Contents
