Roland JX-8P User Manual page 9

Parameter Value Explanation
Adjusts the sensitivity at which velocity
AMP DYNAMICS
0–3
controls the AMP ENV depth.
SINE,
LFO WAVEFORM SQR, Specifies the LFO waveform.
S&H
LFO RATE
0–1023 Specifies the rate of the LFO cycle.
Adjusts the time from when a key is pressed
LFO DELAY TIME 0–1023
until LFO modulation starts being applied.
ENV1 ATTACK
0–1023 Specifies the ENV1 Attack time.
ENV1 DECAY 0–1023 Specifies the ENV1 Decay time.
ENV1 SUSTAIN 0–1023 Specifies the ENV1 Sustain level.
ENV1 RELEASE 0–1023 Specifies the ENV1 Release time.
Specifies the ENV1 key follow in four levels.
ENV1 KEY With higher values, ADR times become longer
0–3
FOLLOW-S as you play lower on the keyboard, and
shorter as you play higher.
ENV2 ATTACK
0–1023 Specifies the ENV2 Attack time.
ENV2 DECAY 0–1023 Specifies the ENV2 Decay time.
ENV2 SUSTAIN 0–1023 Specifies the ENV2 Sustain level.
ENV2 RELEASE 0–1023 Specifies the ENV2 Release time.
Specifies the ENV1 key follow in four levels.
ENV2 KEY With higher values, ADR times become longer
0–3
FOLLOW-S as you play lower on the keyboard, and
shorter as you play higher.
Specifies the range of pitch change produced
BEND PITCH-STEP 2, 3, 4, 7 by pitch bend in four levels: 2, 3, 4, or 7
semitones.
MODULATION
-63–+63 Adjusts the depth of modulation.
LFO
Turns portamento on/off. If this is on, the
PORTA MODE OFF, ON pitch will change smoothly from one note to
the next-played note.
Adjusts the time over which the portamento
PORTA TIME 0–1023
pitch change occurs.
Specifies the pitch change curve for portamento.
Change according to the original curve of
ORIGINAL
the model.
PORTA CRV
LINEAR Change in a linear curve.
EXP1 Change in a non-linear curve (gentle slope).
EXP2 Change in a non-linear curve (steep slope).
Specifies how notes are sounded.
POLY Polyphonic
KEY MODE SOLO Monophonic
UNISON Unison
SL-UNISON Monophonic unison
Sets how much aftertouch changes the LFO
AFT LFO
-63–+63
intensity.
* This is only enabled for products with aftertouch.
Sets how much aftertouch changes the low-
AFT FREQ -63–+63
pass filter intensity.
This is only enabled for products with aftertouch.
Sets how much aftertouch changes the tone
AFT LEVEL -63–+63
volume.
* This is only enabled for products with aftertouch.
Adjusts the slight pitch drift that occurs when
PITCH DRIFT 0–255
notes are played on an analog synthesizer.
If this is ON, the range of change for LFO
PARAM
OFF, ON RATE, CUTOFF, RESONANCE, and FILTER ENV
EXPANSION
DEPTH is wider than on the original model.
Simulates the changes that occur as a unit
CONDITION 0–100
ages.
CC#
29
27
83
80
85
86
89
90
102
103
49
118
5
119
Parameter Guide
9