en Troubleshooting
Fault
"E:30 / -80"
"E:36 / -25 / -26"
"E:38 / -25 / -26"
"E:30 / -10" and/or
All other error codes.
Water cooling
"E:30/-20"
46
Cause and troubleshooting
Remove any unapproved extensions from the water
▶
hose.
→ "Connecting the appliance", Page 14
The pump cap is not fully screwed in.
Ensure that the pump cap is screwed in all the way
▶
into the appliance. The handle on the pump cap
must be in a vertical position.
Drain pump is blocked.
→ "Cleaning the drain pump", Page 41.
▶
Drain pump is blocked.
→ "Cleaning the drum", Page 40
▶
if the fault is displayed again,
→ "Cleaning the drain pump", Page 41
▶
Inlet opening of the rubber gasket is blocked.
→ "Cleaning the intake opening in the rubber gas-
▶
ket", Page 44
The filter in the water inflow is blocked.
Clean the water inflow filter.
▶
The tap is turned off.
Turn on the tap.
▶
The water inlet hose is kinked or jammed.
Ensure that the water inlet hose is not kinked or
▶
jammed.
Malfunction
Call the after-sales service.
▶
→ "Customer Service", Page 55
To protect the wastewater pipes, the hot detergent
solution is cooled before being drained.
Wait until the detergent solution has cooled down.
▶
Solenoid valve defective.
Call the after-sales service.
▶
→ "Customer Service", Page 55
Detergent dosage is too high.
Reduce the amount of detergent for the next wash-
▶
ing cycle with the same load.
Additional water is added.
Do not add any extra water to the appliance while it
▶
is operating.