Hardware Description - Edimax WatchGuard XTM 2 Series Hardware Manual

Hardware Specifications

Hardware Description

All indicator lights are on the front panel of the device, and all ports and connectors are on the rear panel.
Front view
The front panel of the device.
Fail Over
The Fail Over indicator is green when there is a WAN failover from the primary external interface to
the backup interface. After the external interface connection fails back to the primary external
interface the indicator is not lit.
WAP
The WAP indicator is green when an XTM 2-Series wireless device is activated as a wireless access
point. The light is green when traffic goes through the wireless interface.
Network interface status indicators
The status indicators for the six network interfaces are labeled 5, 4, 3, 2, 1, 0. There are two status
indicators for each interface.
Indicator
Link
100/1000
Status
The Status indicator shows when there is a management connection to the device. When you use
your browser to connect to the Fireware XTM Web UI, the indicator is lit. The Status indicator is unlit
a short time after you log out of the Fireware XTM Web UI or close your browser.
Mode
The mode indicator shows the status of the external network connection. If the device can connect
to the external network and send traffic, the indicator is green. The indicator flashes if the device
cannot connect to the external network and send traffic.
Attn
The Attn indicator is lit when you reset the device to factory default settings.
Power (
The power indicator is lit when the device is on.
4
Indicator color
Green
Not lit
Blinks
(speed of blink increases as the
data flow increases)
Not lit
Green
Yellow
)
Interface Status
Power on, connection established
Power off, no connections
Data sent and received
Operates at 10 Mbps
Operates at 100 Mbps
Operates at 1000 Mbps