Advertisement
2
Connecting the Wi-Fi Boxto your modem
Wireless connection to the FIBER BOX X6 or another
companion mode modem (F4000 Gigabit, F3000 Fiber Box)
(recommended :
(fig. 3)
• Wait until the power LED turns white and the Connection
LED starts blinking
red
(fig. 6)
• Press the WPS button on the FIBER BOX X6
2 sec, then press the WPS button of the Wi-Fi Box for 2
sec
The Wi-Fi LED
(fig. 3).
afterwards it will turn steady. The Connection LED will start
blinking green indicating that Wi-Fi Box is being configured.
When the blinking stops, the configuration has finished:
• If the Connection LED is steady
Box is properly connected to Fiber Box X6
• If the Connection LED is steady
Wi-Fi Box is poorly connected or not connected at all to the
FIBER BOX X6. In this case move it closer to FIBER BOX
X6 and repeat the process. Connection LED turning steady
green
or
orange
indicates the end of the connection process,
however, we recommend you try to get the Connection LED
to turn
since this ensures optimal performance.
green
If you are installing multiple Wi-Fi Boxes, repeat the
above-mentioned process.
excellent connection to your FIBER BOX X6
good connexion to your FIBER BOX X6
poor connection to your FIBER BOX X6.
04
.
(+ button)
will start blinking white and
(fig. 6)
green
or orange, your Wi-Fi
red
or blinking red, your
Wired connection to the FIBER BOX X6
• Wait until the Power LED turns white
• Connect the Ethernet cable to your FIBER BOX X6, then to
your Wi-Fi Box.
• The LEDs
connection between the two devices has been established
If you are installing several Wi-Fi Boxes,
for
repeat step 1 Installation and repeat the process.
Note:
When connecting two Wi-Fi Boxes to a FIBER BOX X6, you can
combine the two installation methods – wireless and wired
Wired connection to Non Companion modems
(any modem not listed before)
• Wait until the Power LED turns white
• Connect the Ethernet cable to your modem, then to your
Wi-Fi Box. The Wi-Fi Box connected to your modem serves
as the primary extender.
If you are installing a second Wi-Fi Box power it on and wait
till Connection LED is blinking red.
Press the WPS button on the primary Wi-Fi Box for 2 seconds,
then press the WPS button of the other Wi-Fi Box for 2
seconds. Repeat the process for each additional Wi-Fi Box .
• The LEDs
connection between the two devices has been established.
(fig. 6).
of your Wi-Fi Box will blink until the
(fig. 6)
(fig. 6).
of your Wi-Fi Box will blink until the
(fig. 6)
(fig. 3)
(Fig 3).
05
Advertisement
