Malibu Boats WF540 General Instructions

158WF12680.qxp 2/6/06 3:42 PM
GENERAL INSTRUCTIONS FOR FIBER OPTIC LED WATERFALL USE
1. Unpack the product, wipe off dust with a damp cloth. Take out all
accessories: A bag of small stones, pump and adapter assembly.
2. Familiarize yourself with the pump. The switch located at the front of
it controls the water flow. The flow is indicated by a max and min sign.
To increase flow, move switch in the direction of max. To decrease flow,
move the switch toward min.
FEATURES:
Unique water design-illuminated streams of water create a unique
visual display.
The Waterfall has an audio control. While plugged in, the operation
will be activated by a hand clap or other audio sound. Clap hands
once and LED lights on top in red, blue and green will be on for
a dramatic effect. Clap hands again and the LED lights will be off,
the Fiber optic set on the background will be on which has a
twinkling star.
CAUTION: This pump has been evaluated for use with water only.
NOTE: It is recommended the pump be set at its highest
flow during assembly and later adjusted to a lower setting
if desired. Be sure to unplug pump before adjusting flow
setting.
WARNING: RISK OF ELECTRICAL SHOCK
• Do not connect to any voltage other than that shown on the pump.
• This pump is supplied with a grounding conductor and grounding-type attachment plug. To reduce the risk of
electric shock, be certain that it is connected only to a properly grounded, grounding-type receptacle.
• The national electric code requires that a ground fault circuit interrupter (GFCI) be used in the branch circuit
supplying fountain pumps and other pond equipment. See your electrical supplies dealer for this device.
• If the supply cable is damaged it can not be replaced and the pump unit should be discarded.
WARNING: RISK OF FIRE
• Do not use with water above 30˚C.
• Do not pump flammable liquids.
3. Lead the cord through the cord slot on the bottom of the base. This will ensure that the unit is balanced when placed
on a flat surface. Attach the pump to the connector tube on the Waterfall and attach the AC adapter jack to the base
power cord. DO NOT plug into outlet at this time.
NOTE: Do not let pump run when NOT submerged in water. Doing so may damage the pump. Always submerge
the pump in water first, and then plug in the unit.
4. Fill base with distilled water to approximately 1/2" above pump. Use distilled water only. Tap water will create mineral
deposits that will result in the corruption of the Waterfall and pump.
5. Place the top of Waterfall on base properly.
6. Plug adapter into 120V household outlet.
WARNING: This is not a toy. To avoid danger of choking keep small stones away from Children and Pets.
The product is designed for indoor use only. Do not use outdoors.
NOTE: Ensure that the electrical cord loop is below the electrical outlet." This will prevent water from running
down the cord into the electrical outlet.
Page 1
WF540
Clap hands to
have Waterfall
working