Disposal - Bosch BF.7221.1 User Manual And Installation Instructions

Hide thumbs Also See for BF.7221.1:
Table of Contents

Advertisement

Fault
Food does not heat
up; ​ ⁠ ​ ⁠ ​ ⁠ ​ ⁠ lights up
on the display.
The interior lighting is
not working.
Microwave mode is
cancelled.
Food takes longer
than usual to heat up.
Time not displayed
when appliance
switched off
14.2 Information on display panel
Fault
Message showing "D"
or "E" appears in the
display.
15  Disposal
15.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
1.
Unplug the appliance from the mains.
Cut through the power cord.
2.
Dispose of the appliance in an environmentally
3.
friendly manner.
Information about current disposal methods are
available from your specialist dealer or local author-
ity.
Cause and troubleshooting
Demo mode is activated in the basic settings.
1.
Disconnect the appliance from power supply by briefly switching off the circuit breaker in
the fuse box.
Go to the basic settings and deactivate Demo mode within the next 5 minutes.
2.
→ Page 14
Different causes are possible.
Call the after-sales service.
→ "Customer Service", Page 18
Malfunction
Reset appliance.
1.
Either press and hold
Or switch off the circuit breaker or fuse in the electrical panel. Switch the fuse back
on after approx. 10 seconds.
a If the fault was a one-off, the message will disappear.
If the message appears again, call the after-sales service. Please specify the exact error
2.
message when calling.
→ "Customer Service", Page 18
The microwave power setting is set too low.
Set a higher microwave power setting.
You have placed a larger amount of food than normal in the appliance.
Set a longer cooking time.
You need double the time when you have double the amount.
The food is colder than usual.
Turn or stir the food from time to time during cooking.
Display switches itself off after a short time.
No action required.
Cause and troubleshooting
Malfunction
Reset appliance.
1.
Either press and hold
Or switch off the circuit breaker or fuse in the electrical panel. Switch the fuse back
on after approx. 10 seconds.
a If the fault was a one-off, the message will disappear.
If the message appears again, call the after-sales service. Please specify the exact error
2.
message when calling.
→ "Customer Service", Page 18
​ ⁠ for at least 6 seconds.
​ ⁠ for at least 6 seconds.
This appliance is labelled in accord-
ance with European Directive
2012/19/EU concerning used elec-
trical and electronic appliances
(waste electrical and electronic equip-
ment - WEEE).
The guideline determines the frame-
work for the return and recycling of
used appliances as applicable
throughout the EU.
Disposal en
17

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bf.9221.1

Table of Contents