Table of Contents
Advertisement
CG1-2A H Beam cutter
4.5
Notice of slanting cutting web plate
1．There is an angle scale plate on the fixed track pressure plate. Track mark allocates on
the specified angle which is locked with nuts. Use nuts to lock. Then fix track and machine
on the H structural section.
2．Slanting cutting is different from line cutting. Torch angle needs to be adjusted, otherwise,
cutting is not whole. And some areas are not cut. As shown in the diagram 1.Adjusting
method is shown in the diagram 2 and 3.
When cut wing plates, only recover bevel
graduations to zero.
4.6 Bevel cutting operation
When cutting bevel, use the angle (use 5°as its basic unit)on the
torch holder and allocate the torch on an expected angle. When
choosing a tip for bevel cutting, the thickness of the steel plane
is L as shown in following picture. In order to compensate the
over-dose heat loss due to the bevel cutting, the operator should
choose an upper rank tip based on the Cutting Data. Slight
- 15 -
Advertisement
Table of Contents
