Advertisement
6
model no. 040-1190-4
Insert step bolt (I) into the aligned holes and secure
4
using flat washer (J) and nylon lock nut (K). Tighten
them using 1/2" (13 mm) wrench (not included).
Remove the hexagon
bolts
(2) and washers (3) fitted
5
to the end of the stinger. Align holes at the end of the
stinger (D) with the upper holes of the centre
bracket (A). Insert the washer and hexagon bolt into
the aligned holes. Tighten them using 5/8" (16 mm)
wrench.
Insert the right wheel trays (B) and the left
6
wheel trays (C) onto the rack ams of the centre
bracket (A).
Note: This bike carrier can be fitted to vehicles
equipped with a 1 1/4" (3.2 cm) or 2" (5 cm) hitch
receiver.
• Follow steps 7 to 9 for fitting the bike carrier to
a
2" (5 cm) hitch receiver.
• Follow steps 10 to 12
for fitting the bike carrier
to a
1 1/4" (3.2 cm) hitch receiver.
J
K
I
A
2
3
D
C
B
C
B
A
STINGER INSTALLATION FOR 2" (5 CM) HITCH RECEIVER
Insert the 2" (5 cm) receiver adaptor (4) of the
7
stinger (D) into the 2" (5 cm) hitch receiver (5) of
the vehicle.
8
Insert the anti-sway hitch pin (G) into the aligned
holes of the 2" (5 cm) receiver adaptor and hitch
receiver. Secure the pin using the
spring
washer (M) and flat washer (N).
Tighten the anti-sway hitch pin (G) using
3/4"
9
(19 mm) wrench (not included) and secure it using
the hitch pin clip (H).
7
D
5
4
N
G
M
H
G
Advertisement
