Download
Share
Print this page
Guardian EXPOSURE LAS Manual
  1. Manuals
  2. Brands
  3. Guardian Manuals
  4. Safety Equipment
  5. EXPOSURE LAS
  6. Manual

Guardian EXPOSURE LAS Manual

Hide thumbs

Advertisement

Quick Links

Download this manual
PUG2

Advertisement

loading
Need help?

Need help?

Do you have a question about the EXPOSURE LAS and is the answer not in the manual?

Questions and answers

Related Manuals for Guardian EXPOSURE LAS

Summary of Contents for Guardian EXPOSURE LAS

  • Page 1 PUG2...
  • Page 2 Control Switch with green and red indication LED Control switch cable Guardian Hub Internal emergency Power cable light Internal buzzer Power and signal wires All dimensions are in mm...
  • Page 3 Core OLAS Mobile application Extender - This operates as a repeater to increase the range of the OLAS N2K, Guardian and Core OLAS MOBILE APPLICATION The OLAS mobile application allows the OLAS transmitters to be used as a MOB/proximity alarm if used solely with OLAS transmitters.
  • Page 4 Install a 1-3 A fuse in line with the positive connection Control Switch The Guardian uses a double throw relay enabling it to open or close any circuit. It can be connected in *21mm hole required 1-3A Fuse place or alongside your existing kill switch as it can be installed to perform the same function.
  • Page 5 Switch the vessels batteries ON, powering the Guardian. The Guardian will beep once to indicate switching ON. If there are no OLAS transmitters in range the Guardian hub will beep every minute and the control switch will flash red/green. Note: if the control switch illuminates green and the Guardian hub beeps once it means the OLAS Tag is still switched ON and has been automatically tracked, skip to point 8.
  • Page 6 There are 3 operating states which can be applied to the OLAS Tag (and any other tracked OLAS Transmitters) Index using the OLAS mobile app. The operating state will be stored on the Guardian until it is changed using the Start up or returning to the vessel OLAS mobile application.
  • Page 7 • Press the control switch once to restart tracking. NOTE: if you have removed an OLAS transmitter whilst the Guardian is in paused state it will beep 3 times and remain in the Paused state. 4. TRACKING A PREVIOUSLY TRACKED OLAS TRANSMITTER 10.
  • Page 8 OLAS Smart Lock is a theft deterrent and secondary locking system. When OLAS Smart Lock is enabled, if the Guardian is switched off and back on it will lock the vessels Detection Time (seconds) – adjusting the Detection Time allows a period of time where an OLAS emergency stop system, preventing the engine from being started.

  • Page 9: Specification

    Click on the unlocked gold padlock. ii. Input your Pin Code. OPERATION ACTION/REACTION iii. The Guardian will lock. If the engine is running it will be stopped. Control switch: Green iv. The OLAS mobile app will disconnect from the Guardian. Box: Low red...

  • Page 10: Terms And Conditions

    Test the Connection Whilst In Dock WARNING & WARRANTY Test the connection between the OR and the OT by leaving the OR in its planned location and walk the OT to the furthest point on the vessel. Check that all OTs being used are working correctly by submersing them Any change or modification to this unit not expressly approved by the party responsible for compliance in more than 4 inches of open water which will activate the alarm on the receiver.
  • Page 11 Contact Address Ultimate Sports Engineering Ltd Unit 4 Bury Mill Farm Bury West Sussex RH20 1NN United Kingdom www.exposureolas.com EXPUG18.2...