Table of Contents
Advertisement
SRM-2320T
1.
Remove spark plug and check
for fouling, worn and rounded
center electrode.
2.
Clean the plug or replace with a
new one. DO NOT sand blast to
clean. Remaining sand will
damage engine.
3.
Adjust spark plug gap by
bending outer electrode.
4.
Tighten spark plug to 150-170 kgf•cm (130-150 in•lbf).
Cooling System
Level 2.
To maintain proper engine operating temperatures, cooling air must
pass freely through the cylinder fin area. This flow of air carries
combustion heat away from the engine.
Overheating and engine seizure
can occur when:
• Air intakes are blocked,
preventing cooling air from
reaching the cylinder.
• Dust and grass build up on the
outside of the cylinder. This build
up insulates the engine and
prevents the heat from leaving.
Removal of cooling passage
blockages or cleaning of cooling
fins is considered "Normal
Maintenance." Any failure
attributed to lack of maintenance is
not warranted.
X7732278300
© 08/2019 ECHO Inc.
MAINTENANCE
0.65 mm (0.026 in.)
35
Advertisement
Table of Contents
