Hausmann 6132.468 Instruction Manual page 21

ASSEMBLY
2. Place the assembled frame on the boards. Thread pan head wood
screws (R) with washers (S) through slots in frame into the five holes
used in each board.
NOTE: The center screws lock the board tops in position and have one
washer (S) under the screw head and one additional washer (S) between
the frame and the board. See Figure 8.
Center screw requires extra washer
between tabletop and frame.
To use Work Station with a table saw, use largest opening so debris does
not accumulate. Drill holes as needed into tabletop. Mount tool with nuts and
bolts (not included). See Figure 9.
Be careful to avoid the frame when drilling holes.
Failure to use largest opening with larger bench tools
could cause fire.
Fig. 8
Fig. 9
21