Intermatic ET100 SERIES Programming Manual

ET100 SERIES EASY-SET BASIC PROGRAMMING
RESET TIME SWITCH:
1. Place the two position switch to AUTO and the three position
switch to RUN.
2. Press the RESET switch for 3-5 seconds to reset the
microprocessor memory and clear all programmed information. The
display will flash 12:00 AM.
NOTE: Do not press the RESET switch after programming has begun
or you will loose all of your programmed information.
TO SET PRESENT TIME OF DAY:
1. Place the two position switch to AUTO and the three position switch
to TIME SET.
2. Press the HOUR and MIN buttons separately to select the current
time of day. Note that this timer is a 12 hour AM/PM time clock.
TO PROGRAM TIMES :
1. Place the three position switch to PROGRAM. Note that the display
now shows 0:00 1 for Event #1. There are 8 possible programmed
times (events), 4 ON and 4 OFF. All available events need not be
used.
2. Press the HOUR and MIN buttons separately to program the first
ON time desired.
3. Press the EVENT button once. Note that the display now shows
0:00 2 for Event #2.
4. Press the HOUR and MIN buttons for the first OFF time. If more
than 1 ON and 1 OFF time (event) is required per day repeat this
procedure for up to 4 ON and 4 OFF times (events).
5. Return the three position switch to the RUN position and make sure
the two position selector switch is in the AUTO position.
TO REVIEW PROGRAMMED TIMES:
1. Place the three position switch to PROGRAM.
2. Press the EVENT button to review each of the 8 set points.
TO CHANGE PROGRAMMED TIMES:
1. Place the three position switch to PROGRAM.