Summary of Contents for DIY CREW PAPER ROLL CUTTER
- Page 1 PAPER ROLL CUTTER Packing List Metal Triangle Based (2 PCS) Wooden Dowel (1 PIECE) Metal Blade (1 PIECE) Spring Arm (2 PCS) Metal Rod (2 PCS) Rubber Feet Wall Anchor Small Screw #2 Wall Screw Metal Screw #1 (6 PCS) (4 PCS) (6 PCS) (6 PCS)
- Page 2 Assembly instruction STEP 1 Connect the metal rods to the base Use 4 screws (#1) and a screwdriver to connect them. STEP 2 Connect the blade to the arms Use 2 small screws (#2) and a screwdriver to adjust them. Note: The blade’s tab should be inserted inside the arm’s slot.
- Page 3 Troubleshooting What to do if paper is not getting cut properly? The most common reason for uneven cuts is the blade not being installed correctly. Make sure the blade tabs are inserted inside the arm’s slots. This will ensure the blade stays in the right position and prevents bending.
Need help?
Do you have a question about the PAPER ROLL CUTTER and is the answer not in the manual?
Questions and answers