Section Five-Output Of The Meter - RuoShui 01+ Operation Manual

Figure 3-1 replacing batteries
Section Four - Power on/Power off the Meter
(1) Turn on/off the meter
Press 〔power〕key to switch on the meter, and
repress 〔power〕 key for more than 1 second to cut off the
power.
When turning on the power, the meter starts to make
inner diagnose and display in full screen, and then
undertakes corresponding operation.
To ensure correct electrifying operation, please wait
for 5 seconds to turn on the meter again after cutting off
the power.
이 자료는 저작권법에 따라 보호받는 저작물이므로 무단배포 및 무단복제를 금하며, 내용을 이용하려면, 한국 VictorRuoshui 社
의 서면동의를 받아야 합니다.
www.victorruoshui.co.kr
Note
(2) Automatically turn off the power
The default factory value is set as: the meter will
automatically turn off if no operation has been made
within 15 minutes.
The Users can set by themselves to choose whether
using this function or not (See Section Six).

Section Five-Output of the Meter

The meter generates DC current or simulate
resistance set by the Users from the corresponding
output terminals (OUTPUT).
Do not apply any voltage to output terminal;
otherwise damage to interior circuit may occur if the
voltage is not proper.
(1) DC voltage output
Insert the testing probe into the jack of the meter‟s
1.
output terminal (TC/mV), and connect the other end
with input terminal of the Users‟ meter, see Figure
5-1:
Press 〔FUN〕key , select V function, and display
2.
„mV‟ unit;
Press 〔RANG〕key, select range 100.00mV or
3.
1000.0mV;
Press 〔〕/〔〕key, select output set bit;
4.
Caution