Advertisement
REPAIR
The following maintenance requires professional or qualified maintenance
personnel to perform maintenance
1. Electronic control maintenance
Open the back cover to repair the electrical part.
ELECTRIC
CONTROL BOX
DEHUMIDIFIER STORAGE
When you do not use this product for a long time and plan to store or
collect it, pay attention to the following steps:
1. In the power-on state, press the drain button, wait for a while, and
press it again until the water is drained.
2. Roll up the power cord and water hose and secure them in place.
3. Clean the filter.
4. Place in a cool, dry, relatively dust-free environment. Do not place in
chemical environment.
TROUBLESHOOTING
If the following conditions occur, please confirm the following conditions
before requesting customer service:
DESCRIPTION
POTENTIAL CAUSE
Is the power cord properly
connected?
Machine
Is the room temperature above 5°C
Not Running
or within 38°C?
Is the filter blocked?
Does Not
Are the air inlets or
Dehumidify
air outlets blocked?
No Wind Enters
Is the filter blocked?
Is the machine placed at an angle?
Loud Noise
When Running
Is the filter blocked?
When the LCD screen displays El,
the humidity sensor is faulty or the
wiring of the humidity sensor is not
Error Code: E1
plugged in properly or the ambient
temperature is <10 degrees or >98
degrees
When the LCD screen displays E4,
Error Code: E4
it is full water protection
When the LCD shows LO, the
humidity sensor is faulty or the
Error Code: L0
humidity sensor wiring is not
plugged in properly. or ambient
temperature ≤ 5 degrees
When the LCD screen displays HI,
the humidity sensor is faulty or the
Error Code: Hi
wiring of the humidity sensor is not
plugged in properly. or ambient
temperature ≥ 38 degrees
Water Leakage
Discounted or clogged water pipes
SOLUTION
Connect the plug and socket
Machine must operate at normal
operating temperature
Clean the filter
Clear the blockage from the
air inlet or outlet
Clean the filter
Move the machine to a flat,
sturdy location
Clean the filter
Replace the humidity sensor or
check if the wiring is loose, and
reinsert it. If the ambient temper-
ature is <10 degrees or > 98 de-
grees, it is normal display
Dump the water in the tank or
reinstall the tank so that the float
switch can contact normally
Replace the humidity sensor or
check for loose wiring and plug
it back in again. If the ambient
temperature is 5 degrees, it is
normal display
Replace the humidity sensor or
check if the wiring is loose, and
reinsert it. If the ambient temper-
ature is ≥ 38 degrees, it is normal
display
Check the connection and status
of water pipes
Advertisement
