Advertisement
PRODUCT ICON
FRONT
CONTROL PANEL
AIR INLET
BACK
GRIP HANDLES
ON/OFF
AIR OUTLET
FILTER
KEY FUNCTION
1. ON/OFF BUTTON
FRONT PANEL
Press this button, the machine starts to run, press this button again, the machine
stops, and the fan turns off after a delay of one minute.
2. TIME ON/OFF BUTTON
Press this key to set the timing power on and timing power off. The value range is
0-24 hours. After pressing this key, the digital display starts to flash, and then
press the up and down keys to set the value. After the setting is completed, the
flashing stops within 5 seconds, indicating that the input is completed and the
timing task is executed. If the machine is turned off by pressing the timer key to
set it, it will be turned on within the specified time. Press the timer button to set it
when it is turned on, and it will shut down within the specified time. If you forget to
set the time, you can press the timer switch to check the remaining time.
3. WIND SPEED BUTTON
Used to switch between high and low wind speed.
4. UP
Used to adjust the set humidity and timing. Used in conjunction with functions with
digital adjustment to adjust numbers. In the case of no functional cooperation, pressing
the up or down key does not respond. After entering the humidity setting, each time it
is pressed to rise or fall by 1%, when the humidity setting is less than 35%, it will
display "CO", that is, the continuous operation mode. After entering the timing setting,
each time you press it up or down by 1%, when the humidity setting is less than 35%,
it is set to a non-timing state, and the humidity is set to the 50% position. (Press and
hold the up and down keys for 2S at the same time to perform manual drainage)
UNIVERSAL
5. Status light display
WHEEL
When the corresponding working state is executed, the associated light will be on or
flashing.
INSTRUCTIONS
TIME ON/OFF
UP
DOWN
DOWN
STATUS LIGHT
DISPLAY
WIND SPEED
Advertisement
