DCL MINE-X SOOTFILTER Accompaniment To The Installation, Operation And Maintenance Manual page 10

2.6.1 Installation Instruction For Filter Units
1) Install filter unit gasket on high pressure chamber wall.
2) While holding the handle, install filter unit on high pressure chamber wall by pushing it into the
filter holder.
3) Install and fasten 14 flanged nuts on high pressure chamber wall to 50~75 ft-lb torque.
4) Install filter access panel gasket on low pressure chamber wall.
5) Install filter access panel on low pressure chamber wall.
6) Install and fasten flanged nuts on low pressure wall to 50~75 ft-lb torque.
7) Repeat steps 1-6 for the other filter units (equal numbers on each side of the housing).
2.6.2 Installation Instruction For Spare Filter Unit Cover
1) Install filter unit gasket on the spare filter slot on the high pressure chamber wall.
2) Install spare filter cover on the high pressure chamber wall.
3) Install and fasten 14 flanged nuts on high pressure chamber wall to 50~75 ft-lb torque.
4) Install filter access panel gasket on low pressure chamber wall.
5) Install filter access panel on low pressure chamber wall.
6) Install and fasten flanged nuts on low pressure wall to 50~75 ft-lb torque.
7) Repeat step 1-6 on the opposite side of the housing.
2.6.3 Installation Instruction For Rupture Disc
1) Install rupture disc gasket on the high pressure chamber wall.
2) Install rupture disc aligner on the high pressure chamber wall.
3) Install rupture disc on the high pressure chamber wall.
3) Install and fasten 14 flanged nuts on high pressure chamber wall to 50~75 ft-lb torque..
4) Install rupture disc access panel gasket on low pressure chamber wall.
5) Install rupture disc access panel on low pressure chamber wall.
6) Install and fasten flanged nuts on low pressure wall to 50~75 ft-lb torque.
®
DCL MINE-X SOOTFILTER
INSTALLATION, OPERATION, AND MAINTENANCE MANUAL
LAST REVISED: SEPTEMBER 2009
MINE-X SOOTFILTER
®
8/16